Reviews Wireless Communication Antenna

wlaniot 2.4G Wireless Mini PCI PCI-E WiFi Bluetooth Internal Antenna Built-in Antenna (5dbi,700-2600Mhz,U.FL/IPX Connector,RG178 Cable 4inches) 2pcs

  • ...idth). As client antenna: Connect to an access point in any direction. Designed for wireless 802.11ac and other Dual Band 2.4GHz / 5.8 GHz applications. Omni-directional direct connect antennas tuned to perform on 2.4 & 5.8 GHz networks..
  • Vertically polarized and suitable for many of today’s machine to machine and communication applications such as telemetry, remote monitoring and mesh networking applications..
  • Sends WiFi / wireless signal high and low enough to reach 2 levels of a building. Omni dipole antenna: Radiates signal with a beam of 360 degrees.
  • also receives signal from 360 degrees around it Mounts directly onto RP-SMA-female or SMA-female connector of radio or client device Bottom section of "right angle" version has articulating angle that can be adjusted to 90-degrees or other angle. The versions with an all-brass base (connector section) are waterproof / weatherproof rated IP65..
  • Product name:5.8G Omnidirectional Antenna Type:2.4/5.8G Connector: RP-SMA female V.S.W.R: Less than =1.8 Antenna gain:2dbi Frequencies: 2.4GHz ~ 2.5GHz 4.9GHz ~ 5.8GHz Function:Transmitt....
Check Stock

Deegoo-FPV NEW 12pcs NRF24L01+ 2.4GHz Arduino Wireless RF Transceiver Module

  • Maximum operating speeds up to 2Mbps, GFSK modulation efficiency, Anti-interference ability, Particularly suitable for industrial control applications..
  • 125 Communications channels, Multi-point communication and frequency hopping to meet the communication needs..
  • Built-in hardware CRC error detection, Multipoint communication address control. Built-in 2.4Ghz antenna..
  • nRF24L01 is a single chip radio transceiver for the worldwide 2.4 - 2.5 GHz ISM band. Compatible with Arduino and Raspberry Pi..
  • Applications: wireless peripherals, remote control systems such as RC vehicles and consumer remote electronics, wireless voice transmission such as VoIP, wireless sensor networks, wireless networks, home and commercial automation..
Check Stock

2.4G 5.8G 5GHz Small Mini WiFi Bluetooth RP-SMA Antenna for Router PC Asus ASRock Mini-itx Motherboard TuffTalk WiFi 6 Card FPV TX Transmitter Thinkcentre Security IP Camera Video Surveillance Monitor

  • ...idth). As client antenna: Connect to an access point in any direction. Designed for wireless 802.11ac and other Dual Band 2.4GHz / 5.8 GHz applications. Omni-directional direct connect antennas tuned to perform on 2.4 & 5.8 GHz networks..
  • Vertically polarized and suitable for many of today’s machine to machine and communication applications such as telemetry, remote monitoring and mesh networking applications..
  • Sends WiFi / wireless signal high and low enough to reach 2 levels of a building. Omni dipole antenna: Radiates signal with a beam of 360 degrees.
  • also receives signal from 360 degrees around it Mounts directly onto RP-SMA-female or SMA-female connector of radio or client device Bottom section of "right angle" version has articulating angle that can be adjusted to 90-degrees or other angle. The versions with an all-brass base (connector section) are waterproof / weatherproof rated IP65..
  • Product name:5.8G Omnidirectional Antenna Type:2.4/5.8G Connector: RP-SMA female V.S.W.R: Less than =1.8 Antenna gain:2dbi Frequencies: 2.4GHz ~ 2.5GHz 4.9GHz ~ 5.8GHz Function:Transmitt....
Check Stock

DORHEA 10PCS NRF24L01+ 2.4GHz RF Radio/Wireless Transceiver Module Compatible with Raspberry Pi

  • NRF24L01 is a single chip radio transceiver for 2.4 - 2.5 GHz ISM band, low operating voltage : 1.9 ~ 3.6V low voltage operation..
  • Built-in hardware CRC error detection, Multipoint communication address control, built-in 2.4Ghz antenna, add wireless capability to your projects..
  • 125 Communications channels frequency points, multi-point communication and frequency hopping to meet the communication needs..
  • Applications: wireless peripherals, remote control systems such as RC vehicles and consumer remote electronics, wireless voice transmission such as VoIP, wireless sensor networks, wireless networks, home and commercial automation. Compatible with Arduino and Raspberry Pi..
  • Maximum operating speeds up to 2Mbps, GFSK modulation efficiency, Anti-interference ability, Particularly suitable for industrial control applications, for easy implementation into designs without additional hardware..
Check Stock

HiLetgo 2pcs Xbee Adapter Xbee USB Adapter FT232RL USB to Serial Adapter for XBEE Arduino

  • Maximum operating speeds up to 2Mbps, GFSK modulation efficiency, Anti-interference ability, Particularly suitable for industrial control....
  • 125 Communications channels, Multi-point communication and frequency hopping to meet the communication needs..
  • Built-in hardware CRC error detection, Multipoint communication address control. Built-in 2.4Ghz antenna..
  • nRF24L01 is a single chip radio transceiver for the worldwide 2.4 - 2.5 GHz ISM band. Compatible with Arduino and Raspberry Pi..
  • Applications: wireless peripherals, remote control systems such as RC vehicles and consumer remote electronics, wireless voice transmission such as....
Check Stock

FPV Small WiFi Antenna 2.4GHz Wireless Module Omni Directional Thumb Antenna mmdvm Network Router Antenna SMA Male TX RX Mini RHCP Racing Drone Antenna for Multicopter WiFi USB Adapter Pack of 2

  • This Mini WiFi Bluetooth antenna could be used on drone transmitter&receiver and PC motherboard.
  • The 2.4GHz small WiFi antenna will assist your network devices get a stronger signal reception and a stable connection, no dropouts when use them.
  • Compatibility with wireless standards & applications.
  • Vertically polarized and suitable for many of today’s machine to machine and communication applications such as telemetry, remote monitoring and mesh networking applications..
  • Polarization Omnidirectional,Maxlmum input Power:50W.
  • Application:wireless network router, PCI PCIe network card,notebook PC computer external USB adapter, WLAN AP & Hotspot wireless range extender, FPV camera, etc.
  • Package Content : 2 x 2.4GHz Short WiFi Antenna.
Check Stock

Fancasee (2 Pack) BNC Radio Antenna with BNC Male Plug Jack Connector Adapter Telescopic Stainless Steel HF VHF UHF BNC Antenna for Portable Mobile Handheld Radio Scanner Police Scanner Receiver

  • Excellent 2-pack replacement BNC radio antenna, telescopic BNC antenna, HF VHF UHF bnc antenna..
  • This BNC connector antenna compatible with portable mobile handheld digital desktop radio scanner, radio media system, communication receiver, police radio scanner, CB radio, sound voice machines, PA system, VHF UHF wireless system, remote receiver, radio controlled receivers, frequency counter etc. which use a BNC male connector antenna..
  • Minimum shortened length 6.7 inch. 7-sections telescopic stainless steel bnc radio antenna. This bnc radio antenna can freely rotate to adjust the best signal receiving position..
  • Easy Installation, Plug-n-Play, bnc male plug connector radio antenna, very easy to install and use..
  • More simple and effective, this bnc radio antenna provide a better radio solution..
Check Stock

2Pcs NRF24L01+PA+LNA RF Wireless Transceiver Module with SMA Antenna 2.4G 1100m & Wireless Module with Breakout Adapter On-Board 3.3V Regulator

  • NRF24L01+PA+LNA Wireless Transceiver Module is a 2.4GHz ISM band transceiver, compatible with Raspberry Pi. Auto-acknowledge and auto-retransmit abilities.
  • Support up to six channels of data reception.
  • the transceiver come with power amplifier and SMA antenna, which make the effective communication distance has been greatly expanded..
  • A host microcontroller can communicate and configure the nRF24L01+ over a 4-pin Serial Peripheral Interface (SPI). The configuration registers are accessible through the SPI connection. Configurable parameters include frequency channel (125 selectable channels), output power, and data rate (data rates: 250kbps, 1Mbps, and 2Mbps)..
  • RF24L01+ Breakout Adapter: Small power on SMD LED indicator, On-board 3.3V voltage regulator, which accepts +5V power supply input and provides 3.3V for the attached "nRF24L01+" module..
  • Applications:It can be wildly used in wireless remote control such as RC planes/vehicles, wireless audio, wireless voice transmission such as VoIP, wireless networks, smart home,somatosensory devices, RFID, NFC etc..
  • Package Included:2 x NRF24L01+PA+LNA Wireless Transceiver Module+2 x SMA Antenna+2 x NRF24L01+ Breakout Adapter.
Check Stock

The Plague

  • WIRELESS GAMING HEADSET ELECTRO PUNK EDITION - Sporting a black-and-pink cyberpunk theme, the ROG Strix Go 2.4 Electro Punk Headphone is WORLD'S FIRST....
  • IMMERSIVE GAMING EXPERIENCE - The ROG Strix Go 2.4 Electro Punk headphones have an exclusive airtight chamber design & feature 40mm ASUS essence....
  • MULTI-PLATFORM GAMING HEADPHONES - This wireless dual antenna gaming headset features USB-C 2.4 GHz RF technology & a 3.5mm connector. Enjoy....
  • CLEAR IN-GAME MIC COMMUNICATION – Featuring an Ai-POWERED NOISE-CANCELLING MICROPHONE, this gaming headset utilizes a deep-learning database that....
  • LIGHTWEIGHT HEADSET DESIGN - This foldable and extremely lightweight headphone provides three hours of use with just a 15-minute fast charge and up to....
Check Stock

Real Good Blues

  • STAY CONNECTED: The BEARCAT 980 SSB CB Radio allows you to stay connected while out on the road and is great for people with a long drive ahead of them.
  • LARGE EASY-TO-READ DISPLAY & CHANNEL: Illuminated control panel with 7 color personalized display options for easy use in all lighting conditions. Also features easy-to-read laser etched keys.
  • 40 CHANNEL: Full spectrum CB operation & instantly switches to emergency channel 9. Features NOAA weather channels with the push of a button.
  • NEW NOISE CANCELLING MICROPHONE: Noise Canceling Mic reduces background noise for crystal clear communication.
  • WIRELESS MICROPHONE COMPATABILE: The integrated SWR gives perfect antenna matching. Working with the Uniden BC906W CB Wireless Microphone the Bearcat 980 has become more adaptable.
Check Stock

GOWENIC Single Ear Gaming Headset, 3.5mm Single Ear Headphone, 30mm Per 1.2in Driver Unit, with Noise Cancelling Mic, Compatible with PC, for PS4, for Xbox One, Laptop, for PSP

  • Full-Duplex Wireless Headset System. Hollyland Solidcom C1 is true wireless and self-contained communication headset. The package includes 1 master headset and 2 remote headsets, 6 batteries, 4-port charging case, 6 ear cushions, 3 microphone cushions, 1 storage case, etc. Free your hands with no beltpack or base station..
  • Clear Audio Quality for Precise Coordination. Solidcom C1 intercom headset offers a 150Hz-7KHz wide frequency response, premium Acoustic Echo Cancellation performance, clear audio quality, >55dB Signal-to-Noise Ratio,.
  • Stay Connected in 1100ft Coverage. Solidcom C1 headset operates in 1.9GHz frequency band, providing a reliable transmission range up to 1100ft radius LOS with only 35ms latency. Dual-antenna diversity design enhances anti-interference capability, and guarantees secured and stable team communication in complex wireless conditions..
  • Ready Out of Box, Easy to Use. Solidcom C1 wireless headset will automatically connect up when powered on. Each headset weighs only 168g, comfortable to wear. You can mute the mic simply by lifting the mic boom. Ideal for production teams looking for real-time ....
Check Stock

Sena SD1000 Long Range Bluetooth Serial Adapter

  • Wireless Bluetooth replacement of RS-232 communication, works with any standard RS-232 port.
  • Meets Bluetooth specification v2.0 + EDR Class 1.
  • 100 meters nominal transmit distance or up to 1 kilometer with patch antenna.
  • +18 dBm maximum transmit power, -88 dBm (0.1% BER) receive sensitivity.
  • Supports Bluetooth profiles SPP (Serial Port Profile), easy to use Windows configuration tools.
Check Stock

Nelawya 5.8dBi LoRa Antenna N Type Male LoRawan Antenna for RAK MNTD V2 Nebra Bobcat Sensecap Helium Hotspot Miners Grey

  • Frequency Range:902MHz - 928MHz. Gain:5.8dBi.
  • Ultra Low Loss Cable:3 Meter(10ft) Long N Female to RP-SMA Male Low Loss KMR200 Cable Allowing Install The Antenna indoor/outdoor.
  • Industrial Grade Construction Design, Quality Build and Durable Fiberglass Finish Make it More Suitable for All-Weather Operation. Built-in Pure Copper Oscillator for Performance Ultra Distance Signal Transmission..
  • Works with Most of LoRa IoT Application to get more witnesses for more HNT rewards.. Compatible with RAK Bobcat HNT Hotspot Miner, Helium HNT Mining, Low Data Rate Communication Networks, Long Distance LoRa Nodes, IoT & M2M Nodes, Industrial & Environmental Monitoring, Smart Metering Applications, Inventory Tracking, Vending Machine Data & Monitoring, LoRaWAN, Multipoint and NLOS Applications, Wireless Video and Security Systems..
Check Stock