Reviews Pwm Servo Driver
Servo Driver HAT 16-Channel 12-bit I2C Interface PWM Outputs for Jetson Nano Raspberry Pi Zero/Zero W/Zero WH/2B/3B/3B+/4B Supports SG90 MG90S MG996R etc @XYGStudy
- Servo Driver HAT for Raspberry Pi, 16-Channel, 12-bit, I2C Interface.
- Needless to say, the Raspberry Pi is powerful enough in most cases, yet it's not that good at providing precise PWM output. You may have tried to....
- Standard Raspberry Pi 40PIN GPIO extension header, compatible with Raspberry Pi Zero/Zero W/Zero WH/2B/3B/3B+/4B and later version, Jetson Nano.
- I2C controlled, using only 2 pins Standard servo interface, supports common used servo such as SG90, MG90S, MG996R, etc..
- Up to 16-Channel servo/PWM outputs, 12-bit resolution for each channel (4096 scales).
Check StockAoicrie 5pcs PCA9685 16 Channel PWM Servo Motor Driver PCA9685 IIC Module 12-Bit, for Robot or for Raspberry pi Shield Module servo Shield
- It is 5V compliant, which means you can control it from a 3.3V microcontroller and still safely drive up to 6V outputs (this is good for when you want to control white or blue LEDs with 3.4+ forward voltages)..
- Communication Interface: IIC, PCA9685 contain an I2C-controlled PWM driver with a built-in clock..
- 6 address select pins so you can wire up to 62 of these on a single i2c bus, a total of 992 outputs..
- 12-bit resolution for each output - for servos, that means about 4us resolution at 60Hz update rate..
- 16 Channel PWM/Servo Driver IIC interface-PCA9685 for arduino or for Raspberry pi shield module servo shield..
Check StockALAMSCN 5PCS SG90 9g Servo Motor + 16 Channel PWM Servo Motor Driver PCA9685 IIC Module 12-Bit DIY Kit for RC Robot Arm Helicopter Airplane Car Boat Remote Control for Arduino for Raspberry pi
- These SG90 9G micro servo motors have a completely new redesigned PCB and control system to provide more accuracy..
- Its internal gearing and motor are also upgraded to improve dead bandwidth and centering..
- For SG90 9G micro servo motor is far more accurate and safe to use in aircraft which require precise servo movements and perfect centering..
- Apply to remote control helicopters, micro robot, robot arm and boats. Fit for ALL kind of R/C Toys and also make electronics DIY based on Arduino ,Raspberry Pi..
- Package includes: 5PCS SG90 9g Micro Servo + 1PC PWM Servo Motor Driver. Cost-effective kit to meet your DIY needs..
Check StockPCA9685 16 CH 12Bit PWM Servo Motor Driver Board Controller IIC Interface for Arduino Raspberry Pi Zero/Zero W/Zero WH/2B/3B/3B+ and Robot (2pcs)
- Contains an I2C-controlled PWM driver with a built-in clock. It means, unlike the TLC5940 family, you do not need to continuously send it signals tying up your microcontroller.
- 5V compliant, which means you can control it from a 3.3V microcontroller and still safely drive up to 6V outputs, which is good when you want to control white or blue LEDs with a 3.4V+ forward voltage.
- Supports using only two pins to control 16 free-running PWM outputs – you can even chain up 62 breakouts to control up to 992 PWM outputs..
- 3 pin connectors in 4 groups, so you can plug in 16 servos at one time (Servo plugs are slightly wider than 0.1" so you can only stack 4 adjacent ones on 0.1"-hole female headers..
- 12-bit resolution for each output - for servos, that means about 4us resolution at an update rate of 60Hz..
Check StockZOSKAY 1X DS3218 Update servo 20KG Full Metal Gear Digital servo Baja servo Waterproof servo for Baja Cars(Control Angle 180)
- DS3218 20KG Large Torque Digital Servo with precision potentiometers,stable,low noise,waterproof: IP66.
- High-precision metal gears with hard anodizing, CNC aluminium middle Shell, Dual ball bearings.
- Large Torque&speed – 18.5kg.cm (0.16S/ 60°)@5V,maximum 21.5 kg.cm (0.14S/60°)@6.8V Operating travel:180°(PWM 500-2500μs).
- High performance digital standard servo for any crawler.
- and for robot joint activities,TRX 4 Traxxas, SMT10 Mega Truck, SCX10 II,ARRMA Nero 1/8…..
- Package Included: 1 x Digital Servo 1.58x0.79x1.60inch (40x20x40.5mm).
- Weight: 60g (2.12oz) 1 x 25T Adjustable metal servo arm.
Check StockHiLetgo 5pcs Nano I/O Expansion Sensor Shield for Arduino UNO R1 Nano 3.0 Duemilanove 2009
- 14 I/O Pin (servo type with GND, power and signal).
Check StockNema23 2N.m 57 Hybrid Closed Loop Servo Stepper Motor 2Nm 76mm+HSS57 Servo Driver Controller CNC Kit 24-50V DC For CNC Router Engraving Milling Machine
- Name:Nema23 2N.M Servo Motor Driver CNC Kit.
- Servo Driver:HSS57 2-Phase Hybrid Stepper Servo Driver.
- The torque reducing is much lower than open loop stepper motor when it is at higher speed.The high speed performance and torque are enhanced in a....
Check StockLarge Current 50A H-Bridge High-Power Single-Channel Motor Driver Module Semiconductor Refrigeration
- 【H-bridge Driver Module】The drive uses a full H-bridge driver module full-bridge MOSFET driver chip and composed with very low internal resistance and high current. MOSFET H-bridge driver circuit, with strong drive and braking effect, signal isolation chip isolates motor drive effectively..
- 【Effective Protection】With the microcontroller PWM signal isolation, effectively protect microcontroller..
- 【Input Maximum】To achieve the motor forward and reverse rotation, two PWM input maximum 200kHz frequency..
- 【Fully Compatible】Power indicator is schematically clear. The power supply voltage 5V to 15V. 3.3V to 12V, PWM level is fully compatible. High current 50A..
- 【Warm Tips】Ffor your safety and protection of use, our product is tested to ensure trouble-free installation and performance, please rest assured to buy..
Check StockAEDIKO MG996R Servo Motor Control 180 Angle Metal Gear Servo Digital High Speed Torque Servo Motor for Smart Car Robot Boat RC Helicopter 2-Pack (MG996)
- Positioning Speed Without Load: 0.17s / 60 degrees 4.8V.
- Compliant with Futaba, Hitec, Sanwa, GWS, etc ..
- Latest Version: MG996R Servo Motor Which Updated from SG90 and MG90S Micro Servo Motor,Made of High Precision Potentiometer and High Resolution Digital Chip to Ensure Stable Performance and Solve Problems:Unsuitable R / C and Slow Response Time.
- Gear Type: All Metal Gear RC Servo Can Control the Angle Range from 0 to 180, with Precise Control and Gears are Consistent,Which Can Rotate 360 Degrees When Power Off.
- Application: Analog Servo Motor Great for RC Helicopters, Micro Robots,Robotic Arms and RC Rock Crawler, RC Boat Motor,Truck, Boat, Racing Car,Various Remote Control Toys and Arduino Experiments.
Check StockPWM Pulse Generator, DROK Dual Mode Adjustable Function Generator DC 3.3-30V 1-150kHZ 1-9999 Variable Pulse Width Frequency Duty Cycle Square Rectangular Wave Signal Generator Module with Case
- PARAMETER — working voltage DC 3.3-30V.
- DUAL MODE — the signal generator has 2 modes, PWM mode (default) & pulse mode..
- APPLICATION — the signal generator module can be used to generate square wave rectangular wave signals for controlling DC motors or stepper motor driver.
- for servo motors, stepper motors, electric jaws, PLC pulses replacement, etc..
- PROTECTION — with anti-reverse protection, 5.08mm terminal wiring..
- EASY TO OPERATE — the signal generator can control start or stop, it can also connect the external switch to control the output signal ON/OFF..
Check StockYahboom RC Servo Tester 1 8 16 Channels Servo Motors Controller Centering Tool with Over-Current Protection, 2 Control Modes (Servo Tester 8 chan)
- 8-channel independent servo interface and 8 high-precision potentiometers..
- Support manual mode,centering mode,which can be switched by function keys.
- Terminal block (5-8.4V)power supply port,with Over-Current Protection. Compatible with any 5V-8.4V servos..
- Control accuracy: 0.09 degrees(PWM limit small change value 1us).
- Wide range of applications.No need any codes, servo can be controlled by buttons or the adjustable knobs..
Check StockAEDIKO MG995 Servo Motor Control 180 Angle Metal Gear Servo 20KG Digital High Speed Torque Servo Motor for Smart Car Robot Boat RC Helicopter 2-Pack (MG995)
- Positioning Speed Without Load: 0.17s / 60 degrees 4.8V.
- Compliant with Futaba, Hitec, Sanwa, GWS, etc ..
- Latest Version: Micro Servo Made of High Precision Potentiometer and High Resolution Digital Chip to Ensure Stable Performance and Solve Problems:Unsuitable R / C and Slow Response Time.
- Gear Type: All Metal Gear RC Servo Can Control the Angle Range from 0 to 180, with Precise Control and Gears are Consistent,Which Can Rotate 360 Degrees When Power Off.
- Application: Analog Servo Motor Great for RC Helicopters, Micro Robots,Robotic Arms and RC Rock Crawler, RC Boat Motor,Truck, Boat, Racing Car,Various Remote Control Toys.
Check StockHiLetgo BTS7960 43A High Power Motor Driver Module/Smart Car Driver Module for Arduino Current Limit
- 5V isolate with MCU, and effectively protect MCU.
- Voltage indication of motor driver output end.
- Just need four lines from MCU to driver module (GND. 5V. PWM1. PWM2).
- isolation chip 5 V power supply (can share with MCU 5 V)..
- Able to reverse the motor forward, two PWM input frequency up to 25kHZ.
- two heat flow passing through an error signal output..
- Isolated chip 5V power supply (can be shared with the MCU 5V), can also use the on-board 5V supply.
Check Stock