Reviews Gm Starter For 16tooth Flywheel

Rareelectrical MARINE COATED STARTER COMPATIBLE WITH VOLVO PENTA 4.3L 5.0 5.7 350 1998-UP 30450 9000819 3854751 TM000A24301 SAE J1171

  • ...ARTER WILL ALSO REPLACE THE OLDER LARGE STYLE 10MT DELCO STARTERS WITH STAGGERED (OFFSET) BOLT PATTERN! IT PROVIDES HIGHER TORQUE WITH LESS DRAIN ON YOUR BATTERY. THIS STARTER HAS AN 11 TOOTH PINION THAT WILL REPLACE THE OLDER STYLE 9 TOOTH MODELS. FITS MERC, OMC, VOLVO V6 38.
  • V8 ENGINES- GM BLOCK USING A 14.5 INCH FLYWHEEL..
  • UNIT TYPE: DELCO, MERCURY MARINE,TYPE: PMGR,VOLTAGE: 12 VOLTS,KW: 1.7 KW,ROTATION: CW,TEETH/SPLINES: 11 TEETH/SPLINES,PINION/SPLINES OD: 29.5MM / 1.161IN,DE HOUSING NUMBER: 371-12182,MOUNTING HOLE 1: 10.0MM ID UNTHREADED,MOUNTING HOLE 2: 10.0MM ID UNTHREADED,APPROXIMATE WEIGHT: 9.435 LBS / 4.29 KG.
Check Stock

Shorty's Skate Tool The Wench

  • Fitment: Locks flywheel in place when removing harmonic balancer on 6.6L Duramax engines with Allison automatic transmissions..
  • Function: Saves time by locking the flywheel at the transmission instead of having to remove the starter for water pump replacement..
  • Duramax 2500 / 3500 Pickups (Toothed pieces only): Removes metal spring-loaded inspection plate on the bottom of the transmission. Tool should slide into opening toward engine with the top of the tool engaging the teeth of the flywheel..
  • Duramax 4500 / 5500 Trucks (Toothed pieces with screws): Remove the rubber inspection cap on the bottom of the transmission. Insert the tool at the front of the opening to engage the flywheel and hand tighten bolt to hold tool in place..
  • 36mm 12-point Socket: Use with 3/4" square drive to remove harmonic balancer bolt and retorque on installation. 36mm 12 point socket can also be used on axle..
Check Stock

Bolaxin Flywheel Locking Tool with 36mm 3/4 Inch Wench for 6.6L Duramax Engine

  • Locks Flywheel in Place When Removing Harmonic Balancer on 6.6L Duramax Engines with Allison Automatic Transmissions.
  • Saves time by locking the flywheel at the transmission instead of having to remove the starter for water pump replacement.
  • Use 36mm 12-point socket with 3/4 square drive to remove harmonic balancer bolt and retorque on installation.
  • Duramax 2500 / 3500 Pickups – Use toothed pieces only removes metal spring-loaded inspection plate on the bottom of the transmission. Tool should slide into opening toward engine with the top of the tool engaging the teeth of the flywheel..
  • Duramax 4500 / 5500 Trucks -- Use toothed pieces with screws remove the rubber inspection cap on the bottom of the transmission. Insert the tool at the front of the opening to engage the flywheel and hand tighten bolt to hold tool in place..
Check Stock

Chevy/GM Turbo TH-350/TH-400 Black Steel Flywheel/Flexplate Cover

  • Keep debris, dirt, and grime out of your transmission with this flywheel/flexplate dust cover.
  • Fits Chevy engines as well as other GM engines with the starter on the passenger side.
  • Why spend valuable time cleaning up that greasy, rusty, and downright disgusting stock cover.
  • Hardware is not included. Use flywheel cover bolt kit 91303811 or 91303831.
Check Stock

TYC 1-17841 Toyota Corolla Replacement Starter

  • Provides consistent starting power with a high quality solenoid that properly engages the starter drive with the flywheel in your vehicle every time....
  • High standards for components like wiring, brushes, insulation, bearings and coatings for consistent performance in all environmental conditions.
  • High performance machining of the starter casing for ease of installation and solid joining of the starter housing and your vehicle's mounting....
  • 12 Volt, Clockwise Rotation, 10-Tooth Pinion.
Check Stock

XianFeng 22100 Flywheel Locking Tool for 6.6L Duramax Engine with 36mm 3/4 Inch Wench

  • Work on Duramax 2500 / 3500 pickups .Remove metal spring-loaded inspection plate on the bottom of the transmission. Tool should slide into opening toward engine with the top of the tool engaging the teeth of the flywheel..
  • Locking the flywheel at the transmission instead of having to remove the starter for water pump replacement..
  • Toothed pieces with screws---Remove the rubber inspection cap on the bottom of the transmission.Insert the tool at the front of the opening to engage the flywheel and hand tighten bolt to hold tool in place..
  • Forged 36mm socket---Use on the balancer bolt.Use with a 3/4" square drive wrench.
  • Quality tool ---Made of CRV steel with durability, flywheel locking tool is anti-rust and corrosion-resistant.
Check Stock

NEW RAM 11" CLUTCH & BELLHOUSING KIT WITH GM 621 3899621 ALUMINUM BELLHOUSING, FLYWHEEL INSPECTION COVER, CLUTCH FORK BOOT & CLUTCH PIVOT BALL, PRESSURE PLATE, 26 SPLINE DISC, FLYWHEEL, SBC BBC CHEVY

  • Brand New Southwest Speed and Ram Clutch Aluminum Bellhousing and 11" Clutch Kit for use with Manual Transmissions. The kit includes a replica GM 3899621 Bellhousing, Flywheel Inspection Cover, Clutch Fork with Ball Retaining Spring, Throwout Bearing, Clutch Fork Boot, Clutch Fork Pivot, Flywheel, Clutch Disc, Pressure Plate, and hardware (Part # 650-39755, 901180) > Fits transmissions with 1 5/32"-26 spline input shafts and Chevy engines with a 2 piece rear main seal.
  • The Southwest Speed 11" Performance Cast Aluminum Bellhousing is a reproduction of the original 3899621 bellhousing used on GM models with Big Block and Small Block engines > This performance aluminum bellhousing does not have the GM Part # 3899621 casting number but will look, fit, and perform just like original > If you are doing a restoration of an early muscle car, or just want the correct bellhousing to finish that rod project, this bellhousing is the perfect part.
  • Fits: > 1964-1988 Chevy Chevelle, Malibu, Monte Carlo* > 1959-1987 Chevy El Camino* > 1959-1988 Chevy Impala, Caprice, Bel Air, Biscayne, Brookwood, Kingswood, Nomad, Sedan Delivery* > 1963-1981 Chev....
Check Stock

Premier Gear PG-6643 Starter Replacement for Sable V6 01-05 Taurus V6 01-05 1F1U-11000-AA 1F1Z-11002-AA 1F1Z-11002-AARM 1F1U-11000-AA 1F1U-AA

  • Provides consistent starting power with a high quality solenoid that properly engages the starter drive with the flywheel in your vehicle every time....
  • High standards for components like wiring, brushes, insulation, bearings and coatings for consistent performance in all environmental conditions.
  • High performance machining of the starter casing for ease of installation and solid joining of the starter housing and your vehicle's mounting....
  • 1.5kW/12 Volt, Counter Clockwise Rotation, 22-Tooth Pinion.
Check Stock

Premier Gear PG-6692 Starter Replacement for Explorer, Edge, Taurus, MKZ, Flex, MKX, Sable, Police Interceptor Utility, Continental, MKS, MKT, Police Interceptor Sedan, Taurus X , Grey

  • Provides consistent starting power with a high quality solenoid that properly engages the starter drive with the flywheel in your vehicle every time the ignition key is turned.
  • High standards for components like wiring, brushes, insulation, bearings and coatings for consistent performance in all environmental conditions.
  • High performance machining of the starter casing for ease of installation and solid joining of the starter housing and your vehicle's mounting surfaces.
  • Ford, Noseless, Permanent Magnet Gear Reduction.
  • 12 Volt, Counter Clockwise Rotation, 10-Tooth Pinion.
Check Stock

Premier Gear PG-6642 Starter Compatible with/Replacement For Taurus Mercury Sable 2000-2005 YF1U-11000-AA YF1Z-11002-AA S-2103 280-5126 112604 187-6187 520-3230 6642

  • Provides consistent starting power with a high quality solenoid that properly engages the starter drive with the flywheel in your vehicle every time....
  • High standards for components like wiring, brushes, insulation, bearings and coatings for consistent performance in all environmental conditions.
  • High performance machining of the starter casing for ease of installation and solid joining of the starter housing and your vehicle's mounting....
  • 1.5kW/12 Volt, Clockwise Rotation, 12-Tooth Pinion.
Check Stock

PREMIER GEAR PG-3268 Starter Replacement for F150, Mustang, F250, E250, F350, Town Car, Grand Marquis, E150, E150 Econoline, E350, E350 Club Wagon, Bronco, Thunderbird, LTD Crown Victoria, Grey

  • Provides consistent starting power with a high quality solenoid that properly engages the starter drive with the flywheel in your vehicle every time the ignition key is turned.
  • High standards for components like wiring, brushes, insulation, bearings and coatings for consistent performance in all environmental conditions.
  • High performance machining of the starter casing for ease of installation and solid joining of the starter housing and your vehicle's mounting surfaces.
  • 1.4kW/12 Volt, Clockwise Rotation, 10-Tooth Pinion.
Check Stock

Rareelectrical NEW 16 TOOTH STARTER COMPATIBLE WITH JOHN DEERE L118 CUB CADET 364 GMT-12 1180 1215 1641 LT1018 GT1222 GENERAC V-TWIN SABRE SCOTT S LAWN L2048 S2546 393499 394943 399169 75255-A AM38136

  • Compatible with BRIGGS & STRATTON, CASE, CAT, CUB CADET, GENERAC, GM, JOHN DEERE, SABRE and many more... Please verify your OEM part number from your original unit to help ensure fitment..
  • Replaces: BRIGGS & STRATTON: 494198 494490 494990 497401 691262, GENERAC: 75255 75255-A, JOHN DEERE: LG490420 LG497401, ITEM DESCRIPTION: STARTER, UNIT TYPE: BRIGGS & STRATTON, TYPE: PMDD, VOLTAGE: 12, ROTATION: COUNTERCLOCKWISE, TOOTH COUNT: 16, GEAR OD: 40.6MM / 1.598IN, MOUNTING EAR 1: 8.0MM ID UNTHREADED, MOUNTING EAR 2: 8.0MM ID UNTHREADED, MOUNTING EAR 3: 8.0MM ID UNTHREADED, SPECIFICATIONS: 4.25" / 108MM LONG FIELD CASE FOR USE WITH ENGINES WITH ....
  • Replaces: PLASTIC RING GEARS, WEIGHT: 5.67 LBS / 2.58 KG ....
  • Computer tested for consistent Quality and unsurpassed reliability.
  • Starter - Voltage: 12V Rotation: Counterclockwise Teeth On Drive / Splines: 16 Source: Aftermarket.
Check Stock

PIONEER 153 tooth Flexplate+ARP BOLTS Chevy SB 305 327 350 68-85+BB 396 402 427 (Flywheel & Bolts)

  • Chevy/GM polished aluminum flywheel/flexplate dust cover..
  • Fits Chevy/GM Turbo TH-350 and Chevy/GM Turbo TH-400 transmissions..
Check Stock