Reviews Cathode Materials

5mm Super Bright Piranha LED - RGB - Common Cathode (Pack of 100)

  • 5mm Super Bright Piranha LED - RGB - Common Cathode (Ships from US).
  • Size: 5mm Piranha / Superflux LED, Color: Red/Green/Blue (RGB), Luminosity: 9,000-11,000 mcd.
  • Forward Voltage: R(1.8-3.5) B(3.0-3.5) G(3.0-3.5), Current: 20mA, Wavelength: N/A RGB Common Cathode.
  • Viewing Angle: 100-120 Degrees, MountStyle: Through Hole (DIP), Lens Color: Clear.
  • Super bright LEDs, used for mods, RC, adruino, cars, HO Scale models, planes, trucks, adafruit projects, halloween, christmas, PC, Ultra Light, etc....
Check Stock

5mm Super Bright Piranha LED - RGB - Common Cathode (Pack of 20)

  • 5mm Super Bright Piranha LED - RGB - Common Cathode (Ships from US).
  • Size: 5mm Piranha / Superflux LED, Color: Red/Green/Blue (RGB), Luminosity: 9,000-11,000 mcd.
  • Forward Voltage: R(1.8-3.5) B(3.0-3.5) G(3.0-3.5), Current: 20mA, Wavelength: N/A RGB Common Cathode.
  • Viewing Angle: 100-120 Degrees, MountStyle: Through Hole (DIP), Lens Color: Clear.
  • Super bright LEDs, used for mods, RC, adruino, cars, HO Scale models, planes, trucks, adafruit projects, halloween, christmas, PC, Ultra Light, etc....
Check Stock

4Pcs MAX7219 8 Digit 7 Segment LED Tube Display Control Module for MCU/51/AVR/STM32

  • MAX7219 is an integrated serial input / output common-cathode display driver, which connects your microprocessor to a 7-segment digital LED display with 8 digits.This module is compatible with 5V and 3.3V microcontrollers, and you you can use it.
  • Material: PCB+Electronic components, LED color: Red.
  • Only three IO ports are used to drive the eight digit display. MAX7219 supports flicker free displays as well as cascading displays. PCV board four corners of the fixed copper stud, which can effectively precent short circuit accidents happen..
  • Wiring instructions (take the provided program as an example, you can pick any IO port definition can be modified in the program): VCC to 5V, GND to GND, DIN to P00, CLK to P02, CS to P01.
  • Digital tube is 0.36 inch 4-bit integrated cathode digital tube.
  • Note: VCC and GND should not be connected reversed, so as not to burn the chip.
  • 51 MCU P0 port requires pull-up resistor, if your device does not have a pull-up resistor can be connected to other ports data lines..
  • A convenient four-wire serial interface can connect all common microprocessor. Each data can be addressed in the update without rewriting all displays. MAX7219 also allows the user to select each data encoding or no coding..
Check Stock

DAOKI 10PCS LED Display 7 Segment 1Bit 2Bit 3Bit 4Bit Common Cathode 10PIN Red Light for Arduino,DIY + Jump Wire

  • Type:Common Cathode(Note:5643 Series may be Common Cathode or Common Anode, Be suject to part number).
  • Five different LED Display 7 Segment are available to satisfy your different needs..
Check Stock

SEEU. AGAIN 4pcs 8-Digit 7 Segment Module MAX7219 8 Bit Digital Segment Tube LED Display Module Supports Cascade Eight Bit Serial 3 IO Ports for MCU/51/AVR/STM32

  • MAX7219 is an integrated serial input / output common-cathode display driver, which connects your microprocessor to a 7-segment digital LED display with 8 digits.
  • MAX7219 digital display control module, you can use it..
  • The module is compatible of 5V / 3.3V microcontroller.
  • Only three IO ports are used to drive the eight digit display..
  • Only three IO ports are used to drive the eight digit display. MAX7219 supports flicker free displays as well as cascading displays.
  • PCV board four corners of the fixed copper stud, which can effectively precent short circuit accidents happen..
  • Wiring instructions (a program, for example, you can pick any IO port definition can be modified in the program): VCC to 5V, GND to GND, DIN to P00, CLK to P02, CS to P01.
  • Digital tube is 0.36 inch 4-bit integrated cathode digital tube.
  • Note:VCC and GND do not reversed, it would burn the chip.51 MCU P0 port requires pull-up resistor, if your device does not have a pull-up resistor can be connected to other ports data lines..
Check Stock

DC 5-12V/15-160V Stepper Motor Drive,PWM Adjustable Stepper Motor Controller Signal Generator Speed Regulator

  • Power supply: 15-160VDC or 5-12VDC. If you are using 5-12VDC power, positive end connect DC 5-12V Input, negative end connect Common Cathode End..
  • 3 Frequency: High: 5.8KHZ-127KHZ, Mid: 590HZ-15.8KHZ, Low: 82HZ-2.3KHZ.
  • To control the stepper motor, mus connect to the driver.
  • PUL + and PUL- pulsed positive and negative.
  • EN + and EN- is to enable the positive and negative terminals.
  • DIR + and DIR- are the positive and negative directions..
  • Frequency of measurement can amount PUL and common cathode terminal (GND) two ports..
Check Stock

SKOANBE SR721SW 362/361/162 1.5V Button Coin Cell Watch Battery-10 Packs

  • Suitable for the following models: SR721SW, 362/361, SR721, LR58, AG11, LR721, SR721W, SR58, 362A,423,532,601, 280-29, 362-1W,D361, D362, G11,....
  • Long lasting power: SKOANBE adopts new energy technology and insists that every battery undergoes strict quality control and power testing to ensure....
  • Low self-discharge: quality assurance, if stored properly, the annual self-discharge will be less than 2%, after 3 years it can still maintain 90% of....
  • Voltage stability: the use of chemically stable cathode materials, no high and low unstable currents, effectively prevent unstable currents from....
  • You will get: 10 Pack SR721SW Watch battery equipped with the latest plastic packaging technology and peace of mind service.
Check Stock

uxcell Common Cathode 10 Pin 1 Bit 7 Segment 1.1 x 0.79 x 0.35 Inch 0.55\ Red LED Display Digital Tube 10pcs

  • Panel Size: 19 x 12.7 x 8mm / 0.75" x 0.5" x 0.31" (L*W*H).
  • Total Size: 19 x 12.7 x 14mm / 0.75" x 0.5" x 0.55" (L*W*H).
  • Package Content: 10 x LED Digital Display Tube.
Check Stock

uxcell Common Cathode 10 Pin 2 Bit 7 Segment 1.41 x 1.02 x 0.39 Inch 0.8\ Red LED Display Digital Tube 2pcs

  • Panel Size: 35.8 x 25.8 x 10mm / 1.41" x 1.02" x 0.39" (L*W*H).
  • Total Size: 35.8 x 25.8 x 14mm / 1.41" x 1.02" x 0.55" (L*W*H).
  • Package Content: 2 x LED Digital Display Tube.
Check Stock

OWOFYDR 1N5408 Rectifier diode 3A 1000V 3A 1000V axial Electronic Silicon diode DO-201AD(DO-27) (50pcs)

  • 1. Diode model: 1N5408, forward rectification current: 3A.
  • maximum repetitive peak reverse voltage: 1000V.
  • 2. Features: low reverse leakage/high forward surge current capability/high current capability/high temperature welding.
  • 3. Lead-free RoHS-compliant electronic components/molded plastic housing/plated axial leads/through holes.
  • 4. Polarity: The ribbon represents the cathode, and the detailed specification data is shown in the sub-picture of the product.
  • 5. Packed in ESD self-sealing bags with clear labels, which is convenient for you to confirm the model parameters and prevent static electricity generated by friction from damaging electronic materials..
Check Stock

uxcell Common Cathode 10 Pin 2 Bit 7 Segment 0.59 x 0.55 x 0.28 Inch 0.35\ Red LED Display Digital Tube 5pcs

  • Panel Size: 15 x 14 x 7.2mm / 0.59" x 0.55" x 0.28" (L*W*H).
  • Total Size: 15 x 14 x 13.5mm / 0.59" x 0.55" x 0.53" (L*W*H).
  • Package Content: 5 x LED Digital Display Tube.
Check Stock

uxcell Common Cathode 12 Pin 4 Bit 7 Segment 1.18 x 0.55 x 0.28 Inch 0.35\ Red LED Display Digital Tube 5pcs

  • Panel Size: 30 x 14 x 7.2mm / 1.18" x 0.55" x 0.28" (L*W*H).
  • Total Size: 30 x 14 x 13.5mm / 1.18" x 0.55" x 0.53" (L*W*H).
  • Package Content: 5 x LED Digital Display Tube.
Check Stock

uxcell Common Cathode 11 Pin 3 Bit 7 Segment 0.89 x 0.55 x 0.28 Inch 0.35\ Red LED Display Digital Tube 5pcs

  • Panel Size: 22.5 x 14 x 7.2mm / 0.89" x 0.55" x 0.28" (L*W*H).
  • Total Size: 22.5 x 14 x 13.5mm / 0.89" x 0.55" x 0.53" (L*W*H).
  • Package Content: 5 x LED Digital Display Tube.
Check Stock