Reviews Signal Spectrum Analyzers

Skeleton Crew

  • VSWR Bridge with VSWR-DSA800, VSWR-DSA1000 licenses included Frequency range: 1 MHz - 3.2 GHz, Typical Directivity: 30 dB.
  • For DSA815-TG, DSA815, DSA832E-TG, DSA832E, DSA832-TG and DSA832.
  • Used together with Rigol DSA series spectrum analyzers with tracking generators to make S11 measurements.
  • The VSWR bridge connects directly onto the front of Rigol DSA series spectrum analyzers with tracking generators to improve the test accuracy and to avoid the need for cables.
Check Stock

BJ Bridge (BriJ) Pro version

  • VSWR Bridge with VSWR-DSA800, VSWR-DSA1000 licenses included Frequency range: 1 MHz - 3.2 GHz, Typical Directivity: 30 dB.
  • For DSA815-TG, DSA815, DSA832E-TG, DSA832E, DSA832-TG and DSA832.
  • Used together with Rigol DSA series spectrum analyzers with tracking generators to make S11 measurements.
  • The VSWR bridge connects directly onto the front of Rigol DSA series spectrum analyzers with tracking generators to improve the test accuracy and to avoid the need for cables.
Check Stock

Portable TinySA Spectrum Analyzer, SEESII Upgraded V0.3.1 Tiny Frequency Analyzer with Antenna SMA Male to UHF Female Cables, 100kHz to 960MHz MF/HF/VHF UHF Input, 2.8'' Touchscreen Signal Generator

  • ...-in Calibration Signal Generator】When not used as Spectrum Analyzer it can be used as Signal Generator, MF/HF/VHF sinus output between 0.1MHZ-350MHz, UHF square wave output between 240MHz-960MHz. Built-in calibration signal generator that is used for automatic self test and low input calibration..
  • 【Tiny Spectrum analyzers】Switchable resolution bandpass filters for both ranges between 2.6kHz and 640kHz.Color display showing 290 scan points covering up to the full low or high frequency range. Bulit-in rechargeable battery allowing a minimum of at least 2 hours portable use..
  • 【PC Control】Connected to a PC via USB it becomes a PC controlled Spectrum Analyzer.The USB interface implements the Serial over USB (CDC) protocol and there is a large set of commands that can be invoked over the serial interface. These command can be used to perform measurements or update internal settings. The driver for Windows will install automatically after connecting to a Windows PC. The driver for Linux is built into the kernel..
  • 【Package List】1x Tiny Spectrum Analyzer.
  • 1 x SMA Telescopic Antenna.It's very useful as an antenna analyzer for your ....
Check Stock

4c 69 76 65 (Live at the Bridge Hotel)

  • VSWR Bridge with VSWR-DSA800, VSWR-DSA1000 licenses included Frequency range: 1 MHz - 3.2 GHz, Typical Directivity: 30 dB.
  • For DSA815-TG, DSA815, DSA832E-TG, DSA832E, DSA832-TG and DSA832.
  • Used together with Rigol DSA series spectrum analyzers with tracking generators to make S11 measurements.
  • The VSWR bridge connects directly onto the front of Rigol DSA series spectrum analyzers with tracking generators to improve the test accuracy and to avoid the need for cables.
Check Stock

Software Project Manager's Bridge to Agility, The

  • VSWR Bridge with VSWR-DSA800, VSWR-DSA1000 licenses included Frequency range: 1 MHz - 3.2 GHz, Typical Directivity: 30 dB.
  • For DSA815-TG, DSA815, DSA832E-TG, DSA832E, DSA832-TG and DSA832.
  • Used together with Rigol DSA series spectrum analyzers with tracking generators to make S11 measurements.
  • The VSWR bridge connects directly onto the front of Rigol DSA series spectrum analyzers with tracking generators to improve the test accuracy and to avoid the need for cables.
Check Stock

Assembly Language Using the Raspberry Pi: A Hardware Software Bridge

  • VSWR Bridge with VSWR-DSA800, VSWR-DSA1000 licenses included Frequency range: 1 MHz - 3.2 GHz, Typical Directivity: 30 dB.
  • For DSA815-TG, DSA815, DSA832E-TG, DSA832E, DSA832-TG and DSA832.
  • Used together with Rigol DSA series spectrum analyzers with tracking generators to make S11 measurements.
  • The VSWR bridge connects directly onto the front of Rigol DSA series spectrum analyzers with tracking generators to improve the test accuracy and to avoid the need for cables.
Check Stock

Portable TinySA Spectrum Analyzer,SEESII Upgraded V0.3.1 Handheld Tiny Frequency Analyzer 100kHz to 960MHz MF/HF/VHF UHF Input,Signal Generator with 2.8 inch Touch Screen with ESD Protect Function

  • ...-in Calibration Signal Generator】When not used as Spectrum Analyzer it can be used as Signal Generator, MF/HF/VHF sinus output between 0.1MHZ-350MHz, UHF square wave output between 240MHz-960MHz. Built-in calibration signal generator that is used for automatic self test and low input calibration..
  • 【Tiny Spectrum analyzers & ESD Function】Switchable resolution bandpass filters for both ranges between 2.6kHz and 640kHz.Color display showing 290 scan points covering up to the full low or high frequency range. Bulit-in rechargeable battery allowing a minimum of at least 2 hours portable use.The performance of the 2021 latest version 3.1 will be more stable and sensitive, with a new ESD protrcted function enable the product to have a higher antistatic level and a longer service life..
  • 【PC Control】Connected to a PC via USB it becomes a PC controlled Spectrum Analyzer.The USB interface implements the Serial over USB (CDC) protocol and there is a large set of commands that can be invoked over the serial interface. These command can be used to perform measurements or update internal settings. The driver for Windows will install automatically after connecting to a Windows PC. The driver for Linux is built into the kernel..
Check Stock

Portable tinySA Spectrum Analyzer - AURSINC Handheld Frequency Analyzer V0.3.1 with Antenna SMA Male to UHF Female Cables & 30db Attenuator MF | HF | VHF UHF Input for 0.1MHZ-960MHz 2.8'' Touchscreen

  • ...des are installed which will be more stable and sensitive with higher antistatic level and longer service life. NOTE: Due to the old inventory might mix with the new batch, and If you got the old version Tiny spectrum analyzer and want a new one, you could apply a replacement for it..
  • [Frequency Range] Spectrum analyzers like the Tiny spectrum analyzer use a resolution filter that is used to isolate the input power in a small frequency range. This resolution filter is swept across the desired frequency range. The fastest scanning speed occurs with an RBW or 300kHz or wider and is about 2 scans per second. But with increase of the frequency span and decrease of the RBW the scanning speed decreases quickly. A scan from 0MHz to 350MHz with an RBW of 10kHz takes about 2 minutes..
  • [2 in 1 Device] When not used as Spectrum Analyzer it can be used as Signal Generator, MF/HF/VHF sinus output between 0.1MHZ-350MHz, UHF square wave output between 240MHz-960MHz. Built-in calibration signal generator that is used for automatic self test and low input calibration. The Tiny spectrum analyzer contains all the components of a conventional heterodyne swept spectrum analyzer. Color display showing 290 scan points covering up to the full low or high frequency range.
Check Stock

Portable tinySA Spectrum Analyzer - AURSINC Hand Held Frequency Analyzer 2021 Upgraded V0.3.1 | 100kHz to 960MHz MF/HF/VHF UHF Input | ESD Protected Function & 2.8 inch Touchscreen | Signal Generator

  • ...e more stable and sensitive with higher antistatic level and longer service life. Spectrum Analyzer with two inputs, high quality MF/HF/VHF input for 0.1MHZ-350MHz, lesser quality UHF input for 240MHz-960MHz. Switchable resolution bandpass filters for both ranges between 2.6kHz and 640kHz.
  • [Frequency Range] Spectrum analyzers like the tinySA use a resolution filter that is used to isolate the input power in a small frequency range. This resolution filter is swept across the desired frequency range. The fastest scanning speed occurs with an RBW or 300kHz or wider and is about 2 scans per second. But with increase of the frequency span and decrease of the RBW the scanning speed decreases quickly. A scan from 0MHz to 350MHz with an RBW of 10kHz takes about 2 minutes..
  • [2 in 1 Device] When not used as Spectrum Analyzer it can be used as Signal Generator, MF/HF/VHF sinus output between 0.1MHZ-350MHz, UHF square wave output between 240MHz-960MHz. Built-in calibration signal generator that is used for automatic self test and low input calibration. The tinySA contains all the components of a conventional heterodyne swept spectrum analyzer. Color display showing 290 scan points covering up to the full low or high frequency range.
Check Stock

MOOKEERF 2PCS UHF Male Connector PL259 Male to Male Adapter Low Loss UHF Male PL-259 Connector

  • Type - UHF male to UHF male adapter. Used to connect two uhf cb radio connector or uhf coax cable together. Easy to install..
  • Low Loss Low SWR - The attenuates signal of this cb radio connector is less than 0.1db. VSWR< 1.15(DC-1G). Made of brass copper and teflon insulator....
  • Sturdy & Well Made - This pl259 male to male adapter is made of brass copper body and teflon insulator for a good connectivity and reliable signal....
  • Professionally Made: MOOKEERF as pl-259 male adapter manufacturer, each uhf male adapter swept with USA KEYSIGHT E5071C ENA network analyzers. We are....
  • Applications - Suitable for join pl259 adapter cable and device indoors and outdoors. Applicable to CB HAM Radio, VHF Radio, Antenna, SWR Meter,....
Check Stock

35?4400MHz Portable Spectrum Analyzer,3.5 ”TFT Handheld Frequency Analyzer Amplitude Bandwidth Frequency Signal Generator,Tracking Generator Steps Sweep Signal Generator (PLZ-SA354400A 3.5inch LCD)

  • [ Accurately Track ] This portable spectrum analyzer 35‑4400MHz Equipped with a tracking source TG, the frequency of the signal output by the tracking source can accurately track the tuning frequency of the spectrum analyzer..
  • [Output Range]35MHz‑4.4GHz signal source output range, can display and analyze a simple spectrum.The input dBm scope is -80dBm~0dBm, output dBm is 0dBm..
  • [4 Major Modes ]Four major modes: Network mode, Spectrum mode, Point frequency mode, Sweep mode. After power on, the default mode is Network mode..
  • [3.5 Inch Touch Display ] Touch function, without button operation, you can directly click on the touch screen to operate..
  • [Portable ] Handheld spectrum analyzer Easy to carry and tiny , powered by USB-C cable,it can be easily hand‑held for measurement or carried to various places.Made of aluminum alloy material, wear resistance and can provide long service time..
Check Stock

Spectrum Analyzer USB 35-4400M Signal Source RF Frequency Domain Black Analysis Tool with Tracking Source Module Industrial Supplies

  • RF Frequency Domain Analysis Tool. Sweep Bandwidth: 33mHz---4400mHz.
  • Turn on the tracking source output bandwidth 33mhz---3000mhz.
  • Made of fine quality material, the Spectrum Analyzer has a long service life. Small and portable, high accuracy.
  • Signal Source Spectrum Analyzer. Software used on the computer side: NWT4.11.09 version.
  • Computer operating system: Winxp, Win7, Win10.
  • 35-4400M Signal Tracking Source Module is an RF frequency domain analysis tool.
  • Signal Tracking Source Module with Shell. Sweep Step: ≥33-68.75mHz/125Hz, 68.75-137.5mHz/250Hz, 137.5-275mHz/500Hz, 275-550mHz/1kHz,....
Check Stock

AREOTEK 4000mAh Battery Compatible with Fluke BP190 BP-190 B11432 Scopemeter 192 192B 196 196B 196C 199 199B 199C 215 215C 225 225C Analyzer 433 434 435 Rohde&Schwarz FSH3 FSH3TV

  • Compatible Model: FLUKE Analyzers 433,Analyzers 434,Analyzers 435,Scopemeter 192,Scopemeter 192B,Scopemeter 196,Scopemeter 196B,Scopemeter 196C,Scopemeter 199,Scopemeter 199B,Scopemeter 199C.
  • Brand new Fluke ScopeMeter battery replacement, Compatible Battery Part Number: FLUKE B11432,BP190,BP-190.
  • Please ensure both model and battery part number are matched with your device..
  • Rechargeable NiMH battery pack, Voltage: 7.2V, Capacity: 4000mAh.
Check Stock