Reviews Receiver Module

DISH MT2 OTA MODULE [Electronics]

  • An MT2 Over-the-Air (OTA) Module to connect your over-the-air (OTA) antenna directly to your ViP222k or ViP722k DVR satellite receiver.
  • View local, digital, over-the-air channels directly through your satellite receiver by integrating the OTA channels into your Program Guide..
  • An OTA antenna must be installed to use the Module..
  • A satellite signal and a DISH Network programming subscription is required to operate the OTA module..
Check Stock

Taidacent 12V 2A High Power 8mm to 18mm Wireless Charging Mat Module DIY Inductive Modules Wireless Charger Module Power Supply Kit Receiver and Transmitter Offering Technical Support

  • The charging module is an 80mm DC remote module, and the circuit is simple and practical..
  • Transmitting coil: inner diameter 70mm outer diameter 88mm thickness 1.3mm.
Check Stock

Durablow TR2003 Gas Fire Fireplace On/Off Remote Control Kit + Thermostat + Timer for Millivolt Valve, IPI Module, Replaces Wall Switch or Thermostat (Input 100-240VAC)

  • ★★ ATTENTION: This device is NOT a power supply unit. It is a switch designed for connecting to Millivolt valve, or to electric spark ignition module, or can replace wall switch..
  • ▼ All battery powered R.F. 2-button transmitter and receiver box kit gives wireless remote control to a gas heating appliance, such as gas fireplace, fire pit, stove. ▼ This is a simple On/Off remote control, gives an instant & manual control of the flame and heat..
  • ▼ Receiver with LEARN function, snap-on wall plate, and 18-inch wires with connectors to connect MILLIVOLT valve, or electric spark ignition module, or to replace wall switch. ▼ Receiver box dimension: 2.6"x2.4"x1.54". (measure your wall outlet box first).
  • ▼ Replaces Cross Reference Model #: SKY, 1001, 1001-A, 1001TH, 1001T, 1001D 1410, 1410T, 1410-A, 1410TH, RG04-1M, UN3. ▼ LEGAL DISCLAIMER: The Brand name & Model # (if listed) are for cross reference only. All Brands, Trademarks & Model Numbers remain the property of their respective owners..
  • ▼ Includes: Remote transmitter, receiver box, wall mount cover plate, screws, slide switch, wires with connectors, manuals / instructions. ▼ FCC approved. Operates at a range of 20-foot & non-directional RF signal. ▼ Transmitter operates (2) 1.5V AAA bat....
Check Stock

Taidacent 20mm to 80mm Long Distance 12V to 24V Input 5V 2A Output Wireless Power Supply Module Wireless Charging Coil Module Wireless Inductive Coil

  • The transmission voltage is designed with a wide voltage: 12V~24V..
  • Receiver coil size: outer diameter 88mm..
  • Sensing distance: Receive output 5V2A at 20mm.
  • Note: The distance between the two coils need greater than 13mm!.
Check Stock

Drone Racing League: 2017 eSports Tryouts

  • ...ke other versions of LiteRadio 2, which can act as a USB Joystick when connected to a personal computer, suitable for FPV novices to play FPV simulators like EREADRONE.
  • 【About Bind】The stock firmware of the TX module manufactured by our company is ELRS V1.0.0-RC5(the fifth release candidate version) and the Lite receiver and Micro TX Module is V1.1.0.
  • Please note that the firmware version of the Transmitter and the receiver or the TX module should be the same one and then could be bound together. If you don't know the firmware version, please contact us directly and we will solve the problem for you..
Check Stock

Oiyagai 3pcs 433MHz RF Wireless Transmitter and Receiver Module Kit for Arduino/Arm/McU/Raspberry pi (433MHz)

  • 3 x Transmitter module (433MHz) & 3 x Receiver module(433Mhz).
  • These modules are used for projects when you need to communicate wirelessly between 2 devices.
  • It is possible to increase the range by adding a small length of cable which the device will use as an aerial..
  • VCC voltage module operating voltage and good power filtering.
  • Antenna position has also affected the reception of the module, the installation, the antenna as possible straight away from the shield, high pressure, and interference source.
Check Stock

Bose Lifestyle 600 Home Entertainment System, works with Alexa - White

  • Jewel cube satellite speakers are sleek and compact, and create dynamic surround sound.
  • Dimensions (”): Console – 15.98 W x 2.56 H x 10.16 D | Jewel Side speakers (each) – 2.6 W x 6.2 H x 2.6 L | Jewel Center speaker – 6.1 W x 2.7 H x 2.6 L | Bass module – 12 W x 12 H x 12 L.
  • As main components, your purchase include: One Console, 4 OnmiJewel side speakers, One OmniJewel center speaker, One Acoustimass wireless bass module, universal remote control, 2 wireless receivers, One ADAPTiQ headset and Owner’s guide.
  • Front and center speakers have a wired connection, while the 2-rear speakers connect to a wireless receiver and AC power mains. The rear speakers and bass module connect to the front module wirelessly.
  • Supported Audio formats – Dolby Digital, Dolby Digital Plus, Dolby TrueHD, DTS, Multichannel PCM. Video Source compatibility – Support for six 4K/60 video sources (HDMI 2.0/HDCP 2.2).
Check Stock

Low Noise Water Pump, Waterproof Plug and Play Water Pump with Motor, 370 Water Cooling Pump, Durable for RC Boat RC Aircraft Carriers DIY RC Boat RC Warships

  • The power supply method is not to take power from the receiver, battery used is greater than 2S and the voltage is between 7‑28V, need to use a step‑down module to make the operation more stable..
  • Suitable for installation on remote control boats that require water cooling with water‑cooled motors and without water‑absorbing steering gear.
  • Put it to work normally, the temperature will be hot, but it belongs to the normal range and will not affect the use..
  • Under the condition of 5V voltage, the pump works continuously for 15 hours and pumps water continuously..
  • It is waterproof and works well in water, JR plug suitable for plug into the receiver, plug and play..
Check Stock

Happymodel ELRS 2.4GHz RX SX1280 EXPRESSLRS Nano Long Range Receiver EP1 RX

  • The Happymodel 2.4GHz ELRS nano series receiver is an open source program based on ExpressLRS, we have 3 types rx module released..
  • On the basis of PP RX, we have developed the Nano 2.4GHz rx of ESP8285 version named EP1 and EP2. The RF module of EP1/EP2 is the same like PP RX and....
  • Due to the low-latency and high-refresh-rate RF module, they are very comfortable for FPV race and Long Range FPV. And very suitable for Tiny whoop....
Check Stock

ACEIRMC Digital 38khz Ir Receiver Ir Transmitter Sensor Module Kit for Arduino Electronic Building DIY ， Pack of 6 Sets

  • This ir transmitter sensor module is directly launched by a single tube, it requires waveform modulation through the program..
  • It is suitable for infrared communication, infrared remote control, apply to a variety of platforms including for Arduino/51/AVR/ARM.
  • With signal indicating LED, easy to observe and debug..
  • Pin Definitions: (1) Output (2) Vcc (3) GND.
  • IR Infrared Transmitter Module Ir Digital 38khz Infrared Receiver Sensor Module For Arduino Electronic Building Block.
Check Stock

Bluetooth / 802.15.1 Development Tools Adafruit Feather M0 Bluefruit LE

  • Works with all of Adafruit's three basic 315MHz RF receiver modules.
  • Only a transmitter, no receiver module included.
Check Stock

ES100 Present DJ Mix [Explicit]

  • ADK (DIY Soldering Kit) for EverSet ES100 WWVB-BPSK Atomic Clock Receiver IC.
  • Hardware is compatible with Arduino - Atmega328P with Arduino Bootloader.
  • Includes all Parts to build the kit as shown in the Pictures - including 1x ES100-MOD Receiver Module and 1x ES100-MOD Carrier Board.
  • For Demo Program, Libraries, Documentation etc. see Manufacturer's Website.
Check Stock

MEGA 2560 Starter Kit Ultra (100% Arduino IDE Compatible) w/ Battery Holder, Sensors, Modules, Resistor kit and Components (no Supply)

  • ...otor (5V) -Motor driver module for stepper motor ULN2003.
  • 5V Active Buzzer -5V Passive Buzzer -LCD 1602 16 characters * 2 lines -LED Display Driver MAX7219 -LED Matrix Display of 8*8 -7 Segments Display 1 digit -7 Segments Display 4 digits -Simple Relay Module - Infrared Remote Control 38kHz - 38kHz Infrared decoder receiver (type 1838) - Infrared phototransistor (Flame sensor) - Infrared LED - Light sensor (Photoresistor).
  • -10 * LEDs 5mm Diffused RED -10 * LEDs 5mm Diffused GREEN -10 * LEDs 5mm Diffused YELLOW -5 * LEDs 5mm Ultrabright WHITE diffused -3 * LEDs 5mm Red / Green / Blue Diffused RGB -Shift Register (Series to Parallel IC) 74HC595 - NPN Transistor BC547 - PNP Transistor BC557 - Adjustable Knob Resistor 1kOhm (Potentiometer) - Adjustable Knob Resistor 10kOhm (Potentiometer).
  • - Resistor Pack 1/4W 1% accuracy, with 10pz of each value: 100, 220, 330, 470, 1K, 2K2, 4k7, 10K, 22K, 47K, 100K, 220K, 1M - 40-pin header 2.54 mm -40-pin header at right angle 2.54mm -5 * Capacitors for bypass tantalum 0.1uF -5 * Jumpers for header.
Check Stock