Reviews Numeric Display 7 segment Led

ALAMSCN MAX7219 Dot Matrix Module 32x8 4 in 1 LED Display Modules for Arduino Raspberry Pi Microcontroller with 5Pin Wires Red (Pack of 2)

  • The MAX7219 is compact, serial input/output common-cathode display drivers that interface microprocessors (µPs) to 7-segment numeric LED displays of up to 8 digits, bar-graph displays, or 64 individual LEDs..
  • Included on-chip are a BCD code-B decoder, multiplex scan circuitry, segment and digit drivers, and an 8x8 static RAM that stores each digit..
  • Only one external resistor is required to set the segment current for all LEDs. A convenient 3-wire serial interface connects to all common µPs. Individual digits may be addressed and updated without rewriting the entire display..
  • The MAX7219 also allow the user to select code B decoding or no-decode for each digit..
  • The devices include a 150µA low-power shutdown mode, analog and digital brightness control, a scan limit register that allows the user to display from 1 to 8 digits, and a test mode that forces all LEDs on..
Check Stock

48V Battery Fuel Gauge Indicator, Golf Cart, Yamaha,EZGO, Fork Lifts,Club Car,LED Battery Indicator Meter Gauge

  • 【48V Battery Fuel Gauge】The 48 Volt Led Battery Meter compatible with Golf Cart Club Car EZGO Yamaha 48 Volt LED Battery Gauge Meter, Works with 48V Lead-Acid Batteries in Golf Carts, Forklifts, Trucks, Scooters and More..
  • 【LED Battery Indicator Meter】10 segment LED Bar Graph display, 10% per segment：3 color LED display,different light displays different battery level visually.
  • LED flash for low charge&high charge warning.
  • 【Note】The second LED from the left flashes as a warning that the batteries voltage has been discharged to 80% of their capacity.It is strongly recommended to recharge the batteries when you get to the 3rd Yellow LED, this is a safety precaution to avoid dead batteries.
  • 【 Installation Notes】Make sure your "C" terminal is either connected to the Battery "+" or a Key switch, Meter will scan from full to empty then shuts off .Meter will stay full position while first is connected with batteries and indicate the actual battery level after 155 seconds..
  • 【 Battery Indicator】The 48V Battery Indicator is made of high quality ABS material, waterproof, heat resistant, reliable performance.Displayed with 10 segment LED bar graph (1 Red, 2 Yellow and 7 Green LED), different light displays different battery level..
Check Stock

Basic 16x2 Character LCD - RGB Backlight 5V

  • DRIVER IC: The module driver IC is for AIP650 (compatible for TM650), as well as supports multiple display characters..
  • 4 DIGIT 7 SEGMENT: The digital tube display module is designed for 4 digit 7 segment, with stable and reliable performance..
  • CONTROL INTERFACE: With 4 pins, SDA is bidirectional data line, SCL is clock line, GND is for ground line, and VCC is power supply..
  • COMPACT STRUCTURE: The LED digital tube module is exquisite and compact, which can be flexibly used in a variety of situations..
  • WIDE APPLICATION: This module is suitable for Raspberry Pi 3 B+ 4, for DIY electronic devices, toy cars and instrumentation etc..
Check Stock

Key Display for AVR 8-Bit Digital LED Tube 8-Bit TM1638 Module

  • DRIVER IC: The module driver IC is for AIP650 (compatible for TM650), as well as supports multiple display characters..
  • 4 DIGIT 7 SEGMENT: The digital tube display module is designed for 4 digit 7 segment, with stable and reliable performance..
  • CONTROL INTERFACE: With 4 pins, SDA is bidirectional data line, SCL is clock line, GND is for ground line, and VCC is power supply..
  • COMPACT STRUCTURE: The LED digital tube module is exquisite and compact, which can be flexibly used in a variety of situations..
  • WIDE APPLICATION: This module is suitable for 3 B+ 4, for DIY electronic devices, toy cars and instrumentation etc..
Check Stock

MEGA 2560 Starter Kit Ultra (100% Arduino IDE Compatible) w/ Battery Holder, Sensors, Modules, Resistor kit and Components (no Supply)

  • ...Sensor HC-SR501 -Distance measurement module HCSR04 -Sound sensor detector module with programmable threshold -LM35 temperature sensor -Tilt detector module -Servo SG90 motor -Stepper motor (5V) -Motor driver module for stepper motor ULN2003.
  • 5V Active Buzzer -5V Passive Buzzer -LCD 1602 16 characters * 2 lines -LED Display Driver MAX7219 -LED Matrix Display of 8*8 -7 Segments Display 1 digit -7 Segments Display 4 digits -Simple Relay Module - Infrared Remote Control 38kHz - 38kHz Infrared decoder receiver (type 1838) - Infrared phototransistor (Flame sensor) - Infrared LED - Light sensor (Photoresistor).
  • -10 * LEDs 5mm Diffused RED -10 * LEDs 5mm Diffused GREEN -10 * LEDs 5mm Diffused YELLOW -5 * LEDs 5mm Ultrabright WHITE diffused -3 * LEDs 5mm Red / Green / Blue Diffused RGB -Shift Register (Series to Parallel IC) 74HC595 - NPN Transistor BC547 - PNP Transistor BC557 - Adjustable Knob Resistor 1kOhm (Potentiometer) - Adjustable Knob Resistor 10kOhm (Potentiometer).
  • - Resistor Pack 1/4W 1% accuracy, with 10pz of each value: 100, 220, 330, 470, 1K, 2K2, 4k7, 10K, 22K, 47K, 100K, 220K, 1M - 40-pin header 2.54 mm -40-pin header at right angle 2.54mm -5 * Capacitors for bypass tantalum 0.1uF -5 * Jumpers for header.
Check Stock

G-MARK MK800MP3 Professional Audio mixer Console 8 channels with MP3 Player +48V Phantom Power USB Bluetooth Reverb for stage

  • 8 channel mono input with 48V phantom power supply..
  • USB input, with lyrics display, 7-Bit LED display..
  • built-in analog effects with LED display.
  • can be connected to digital effects peripherals.
Check Stock

Pyle PS900 Audio/Video AC Power Conditioner, Voltage Filter, Noise/Interference Elimination, Processor Sequencer with 3-Prong Outlet Plugs

  • Supplies Clean Filtered AC Power: 2-Stage High Insert Dissipation - AC Voltage, Ambient Temperature & Step Time Display.
  • Micro-Controller Ensures High Level Precise Timing - Built-in 2 Stage EMI Filter for Each Output (On Rear Panel).
  • Able to Series Link More than 100 Units with Automatic Master Unit Display - Selectable Step Time and Real Time Display.
  • Output Cut Switch for All Nine Channels - Monitors AC Voltage in Real Time - Display Shows Wiring and Ground Status.
  • LED Displays: Output Cut, Master, Bypass, Power, AC Voltage and Temperature - Step Time Display in 7 Segment LED.
Check Stock

uxcell Common Cathode 10 Pin 2 Bit 7 Segment 0.59 x 0.55 x 0.28 Inch 0.35\ Red LED Display Digital Tube 5pcs

  • Panel Size: 15 x 14 x 7.2mm / 0.59" x 0.55" x 0.28" (L*W*H).
  • Total Size: 15 x 14 x 13.5mm / 0.59" x 0.55" x 0.53" (L*W*H).
  • Package Content: 5 x LED Digital Display Tube.
Check Stock

uxcell Common Anode 10 Pin 2 Bit 7 Segment 0.59 x 0.55 x 0.28 Inch 0.35\ Red LED Display Digital Tube 5pcs

  • Panel Size: 15 x 14 x 7.2mm / 0.59" x 0.55" x 0.28" (L*W*H).
  • Total Size: 15 x 14 x 13.5mm / 0.59" x 0.55" x 0.53" (L*W*H).
  • Package Content: 5 x LED Digital Display Tube.
Check Stock

uxcell Common Cathode 12 Pin 4 Bit 7 Segment 1.18 x 0.55 x 0.28 Inch 0.35\ Red LED Display Digital Tube 5pcs

  • Panel Size: 30 x 14 x 7.2mm / 1.18" x 0.55" x 0.28" (L*W*H).
  • Total Size: 30 x 14 x 13.5mm / 1.18" x 0.55" x 0.53" (L*W*H).
  • Package Content: 5 x LED Digital Display Tube.
Check Stock

uxcell Common Cathode 11 Pin 3 Bit 7 Segment 0.89 x 0.55 x 0.28 Inch 0.35\ Red LED Display Digital Tube 5pcs

  • Panel Size: 22.5 x 14 x 7.2mm / 0.89" x 0.55" x 0.28" (L*W*H).
  • Total Size: 22.5 x 14 x 13.5mm / 0.89" x 0.55" x 0.53" (L*W*H).
  • Package Content: 5 x LED Digital Display Tube.
Check Stock

4-Digit 7-Segment LED Display Clock Module with TM1637 IC Compatible with Raspberry Pi Arduino (Blue LEDs)

  • [Specifications] This is a basic 4-digit 7-segment Led display clock module, the LEDs are blue..
  • [Compatibility] This clock module uses TM1637 IC, it compatible with Raspberry Pi and Arduino.
  • [Easy to Use] The clock module connected to digital I/O via 2 pins..
  • [Easy to Install] This LED display designed with 4 mounting holes for easy installation..
  • [High Quality] The clock module is made of high quality electronic components, stable and reliable performance.
Check Stock

SWAT-Tourniquet, Orange

  • Measuring Range: -100 to +100 Pascals with 4-20 mA O/P.
  • Display: Integrated 4 Digit Red LED 7 Segment Display 0.5”.
  • Maximum Over Pressure : 2 Times the rated pressure.
  • Construction: Aluminium LM-6 Powder Coated Body with Flush Bezel Fitment.
  • Water Splash Proof Polycarbonate Front Sticker.
  • Sensor Type : Integrated High Speed Differential Pressure Sensor.
  • Alarm Type : Built in Buzzer Alarm for Process Violation Alert.
  • Accessories: Instruction Manual, Adapter, Calibration, Traceability.
  • Application: Hospital, Clean Room, Pharmaceutical, Isolation Room.
Check Stock