Reviews High temperature Cable

HEATIT JHSF 120-feet 120V Self Regulating Pre-assembled Pipe Heating Cable

  • JHSF doesn't work unless the ambient temperature is below 37F/3 degree C. Please test the cable in a cold environment..
  • Suitable for use on plastic and metal water pipes.( including inlet pipe,drain pipe, sewer , palm tree frost protection etc). Self regulating heating cable output will adjust automatically based on the ambient temperature at each point along the cable..
  • Pre-assembled, easy to install. Including grounded plug with light, built in thermostat(turn the cable 37F on 50F off) and instructions. 120 volt, 3 watts/ft at 50 degrees F. Protect pipes up to 2" in diameter. Can be used by straight, spiral and overlap..
  • ETL approved. 2 ft 18/3 cold lead with plug. The lowest installation temperature of this heating cable is -10 degree C. Tough XLPE as inner insulation and weather resistant PE (high-low temperature) as out jacket. Ingress Protection 65..
  • Testing the cable before the installation. Uncoil the cable, plug in the heating cable. Normally you can feel the slight warm on the heating cable in few minutes..
Check Stock

HEATIT JHSF 12-feet 120V Self Regulating Pre-assembled Pipe Heating Cable

  • JHSF doesn’t work unless the ambient temperature is below 37F/3 degree C. Please test the cable in a cold environment. HEATIT is registered Trademark by zhukeshi(We didn’t authorize other sellers in Amazon.com)..
  • Suitable for use on plastic and metal water pipes.( including inlet pipe,drain pipe, sewer , palm tree frost protection etc). Self regulating heating cable output will adjust automatically based on the ambient temperature at each point along the cable. No worry about the overheat risk. More Safe. Can be used by straight, spiral and overlap. More functional..
  • Pre-assembled, easy to install. Including grounded plug with light, built in thermostat(turn the cable 37F on 50F off), and instructions. 120 volt, 3 watts/ft at 50 degrees F. Energy-efficient. Protect pipes up to 2″ in diameter. For a better freeze protection, at least 1/2 inch thick insulation material is recommended, especially for extremely cold weather..
  • ETL approved. 2 ft 18/3 cold lead with plug. Industrial grade heat shrinkage tube for connection.The lowest installation temperature of this heating cable is -10 degree C. Tough XLPE as inner insulation and weather resistant PE (high-low temperature) as out jacket. Ingress Protection 65. Durable.
Check Stock

HEATIT JHSF 6-feet 120V Self Regulating Pre-assembled Pipe Heating Cable

  • JHSF doesn’t work unless the ambient temperature is below 37F/3 degree C. Please test the cable in a cold environment. HEATIT is registered Trademark by zhukeshi(We didn’t authorize other sellers in Amazon.com)..
  • Suitable for use on plastic and metal water pipes.( including inlet pipe,drain pipe, sewer , palm tree frost protection etc). Self regulating heating cable output will adjust automatically based on the ambient temperature at each point along the cable. No worry about the overheat risk. More Safe. Can be used by straight, spiral and overlap. More functional..
  • Pre-assembled, easy to install. Including grounded plug with light, built in thermostat(turn the cable 37F on 50F off), and instructions. 120 volt, 3 watts/ft at 50 degrees F. Energy-efficient. Protect pipes up to 2″ in diameter. For a better freeze protection, at least 1/2 inch thick insulation material is recommended, especially for extremely cold weather..
  • ETL approved. 2 ft 18/3 cold lead with plug. Industrial grade heat shrinkage tube for connection.The lowest installation temperature of this heating cable is -10 degree C. Tough XLPE as inner insulation and weather resistant PE (high-low temperature) as out jacket. Ingress Protection 65. Durable.
Check Stock

HEATIT JHSF 80-feet 120V Self Regulating Pre-assembled Pipe Heating Cable

  • JHSF doesn’t work unless the ambient temperature is below 37F/3 degree C. Please test the cable in a cold environment. HEATIT is registered Trademark by zhukeshi(We didn’t authorize other sellers in Amazon.com)..
  • Suitable for use on plastic and metal water pipes.( including inlet pipe,drain pipe, sewer , palm tree frost protection etc). Self regulating heating cable output will adjust automatically based on the ambient temperature at each point along the cable. No worry about the overheat risk. More Safe. Can be used by straight, spiral and overlap. More functional..
  • Pre-assembled, easy to install. Including grounded plug with light, built in thermostat(turn the cable 37F on 50F off), and instructions. 120 volt, 3 watts/ft at 50 degrees F. Energy-efficient. Protect pipes up to 2″ in diameter. For a better freeze protection, at least 1/2 inch thick insulation material is recommended, especially for extremely cold weather..
  • ETL approved. 2 ft 18/3 cold lead with plug. Industrial grade heat shrinkage tube for connection.The lowest installation temperature of this heating cable is -10 degree C. Tough XLPE as inner insulation and weather resistant PE (high-low temperature) as out jacket. Ingress Protection 65. Durable.
Check Stock

HEATIT JHSF 24-feet 120V Self Regulating Pre-assembled Pipe Heating Cable

  • JHSF doesn’t work unless the ambient temperature is below 37F/3 degree C. Please test the cable in a cold environment. HEATIT is registered Trademark by zhukeshi(We didn’t authorize other sellers in Amazon.com)..
  • Suitable for use on plastic and metal water pipes.( including inlet pipe,drain pipe, sewer , palm tree frost protection etc). Self regulating heating cable output will adjust automatically based on the ambient temperature at each point along the cable. No worry about the overheat risk. More Safe. Can be used by straight, spiral and overlap. More functional..
  • Pre-assembled, easy to install. Including grounded plug with light, built in thermostat(turn the cable 37F on 50F off), and instructions. 120 volt, 3 watts/ft at 50 degrees F. Energy-efficient. Protect pipes up to 2″ in diameter. For a better freeze protection, at least 1/2 inch thick insulation material is recommended, especially for extremely cold weather..
  • ETL approved. 2 ft 18/3 cold lead with plug. Industrial grade heat shrinkage tube for connection.The lowest installation temperature of this heating cable is -10 degree C. The minimum bending radius is 1 inch.Tough XLPE as inner insulation and weather resistant PE (high-low temperature) as out jacket. Ingress Prote....
Check Stock

WILLHI WH-1803C PID High Accuracy Temperature Controller Heating 110V 5A Accuracy 0.1 ℃ or 0.1 °F Digital Outlet Thermostat Waterproof Probe for Incubator Wine Brewing Fermentation Temp Control

  • 【High Accuracy】- WH-1803C digital temperature controller specialized for constantly controlling a high accuracy temperature, High frequency PID algorithm with 0.1℉/℃ precision controlling. such as incubator, wine brewing industry, fermentation industry which need a high accuracy temperature point..
  • 【UL Certification power cable】–WILLHI Digital Temperature Controller has high quality power cable, the top quality copper wire can max load 5A currents..
  • 【Heating only】- High accuracy digital temperature controller only work with resistance-type heater for heating, it can’t work with compressor for cooling and motors..
  • 【High and low temperature alarm】 – Place the waterproof probe, plug the power cord in the Temp Controller . Set the maximum desired temperature for the heat mat. Alarm when temperature exceeds the limit or when sensor error..
  • 【Delay Feature】- Our temperature controller built in time delay feature to protect out device from excessive ON/OFF toggling..
Check Stock

TOPDURE JHSD 3-feet Pipe Heating Cable Built-in Thermostat

  • ROOF HEAT CABLE - keeping your pipe/water lines/roofs/gutters from freezing during the winter,functioning perfectly for plastic and metal pipes, all kinds of roofs, keep the water flowing in gutters.
  • SELF-REGULATING TECHNOLOGY - the cable output will change automatically depend on the ambient temperature, the output goes up when the temp is low and goes down when it's high, saving energy and electricity for you, illuminated plug lets you see if the heat cable is working from a distance.
  • HEAVY DUTY CABLE - 6FT cold lead and 6FT/18FT heat cable is commercial grade for long-time and heavy-duty usages, PVA out jacket, 5W/ft under 50°F for heating pipes.
  • EASY TO INSTALL - pre-assembled for quick installation, the heat cable can be straight-traced or spiral on the pipe, be aware that the lowest installation temperature is 14°F and the maximum exposure temperature is 221°F.
  • RELIABLE FOR HEATING PIPES - UL and ETL cerfied, illuminated plug lets you see if the heat cable is working from a distance, please test the cable before the installation, 1 Year warranty provided.
Check Stock

VIVOSUN 4-Pack LCD Digital Aquarium Thermometer Fish Tank Water Terrarium Temperature with Suction Cup for Turtle

  • High Accuracy: Temperature Range: -50℃ ~ +70℃ (-58 °F ~ +158 °F).
  • This aquarium thermometer is accurate to +/- 1℃, no matter whether the probe is placed in any corner of this fish tank, an accurate temperature will be displayed.
  • LCD Display: Comes with a large LCD display that is easy to read clearly and accurately.
  • Adjustable Unit Temperature: Easy to adjust the temp between Fahrenheit and Celsius displays.
  • Long-press the power button to adjust the unit display.
  • Two Suction Cups: Equipped with two suction cups, one for attaching the cable to the side of the tank and another for attaching the thermometer.
  • Super Long Cable: The cable length connected to the probe is 78.74 inch (2 m) superior to 23.62 inch (60 cm) standard cable length.
  • Allows accurate temperature measurements in even the largest fish tanks.
Check Stock

VIVOSUN 2-Pack LCD Digital Aquarium Thermometer Fish Tank Water Terrarium Temperature with Suction Cup for Turtle

  • HIGH ACCURACY: Temperature Range: -50 ~ +70 (-58 F ~ +158 F).
  • This aquarium thermometer is accurate to +/- 1, no matter whether the probe is placed in any corner of this fish tank, an accurate temperature will be displayed.
  • LCD DISPLAY: Comes with a large LCD display that is easy to read clearly and accurately.
  • ADJUSTABLE UNIT TEMPERATURE: Easy to adjust the temp between Fahrenheit and Celsius displays.
  • Long-press the power button to adjust the unit display.
  • TWO SUCTION CUPS: Equipped with two suction cups, one for attaching the cable to the side of the tank and another for attaching the thermometer.
  • SUPER LONG CABLE: The cable length connected to the probe is 39.37 inch (1 m) superior to 23.62 inch (60 cm) standard cable length.
  • Allows accurate temperature measurements in even the largest fish tanks.
Check Stock

Refrigerator Thermometer,Freezer Thermometer,high and Low Temperature Alarm,Extra Sensor

  • Main unit is attached to the outside of the refrigerator by magnets,extra sensor put inside,high and low temperature....
  • indoor or outdoor temperature test outdoor probe cable length is 1.5 meters(the probe cable heat-resistant up to 110°C).
  • indoor or outdoor temperature range:-58°F --+158°Faccuracy:±1°C,Resolution:0.1°C,.
  • Multi-site application, refrigerator, freezer, crawler, aquarium, etc., the product is placed for external use, the probe is placed in the environment....
  • when the actual temperature is higher or lower than the set temperature, the product will alarm for 30 seconds, when the temperature is higher or....
Check Stock

HEATIT HISD 18-feet Pipe Heating Cable with Built-in Thermostat

  • ...all and use. 120 volt, 7 watts/ft. Built in thermostat to turn the cable 37F on 50F off. Energy saving. 100% screen rate with the Aluminum foil and tinned copper braid..
  • Both CSA and ETL approved. Industrial grade heat shrinkage tube for connection. Tough XLPE as inner insulation and weather resistant PVC (high-low temperature) as out jacket..
  • Maximum 1/2 in fiberglass insulation was used over the heating cable for lower temperature protection. Pipes must be at least 3 feet and at least 3/8” and less than 1 1/2” in. diameter. No crossing. No spiral. No overlap itself. Only straight..
  • Testing the cable before the installation. Uncoil the cable, plug in the heating cable and then put the thermostat part of the cable into an ice bucket for few minutes. When the temperature is below 37F, the thermostat will energize the cable to work. Normally you can feel the slight warm on the heating cable in few minutes. To avoid the overheat, please don’t plug in the cable for a long time for testing. When you feel the slight warm, please turn it off..
Check Stock

HEATIT HISD 15-feet Pipe Heating Cable with Built-in Thermostat

  • ...all and use. 120 volt, 7 watts/ft. Built in thermostat to turn the cable 37F on 50F off. Energy saving. 100% screen rate with the Aluminum foil and tinned copper braid..
  • Both CSA and ETL approved. Industrial grade heat shrinkage tube for connection. Tough XLPE as inner insulation and weather resistant PVC (high-low temperature) as out jacket..
  • Maximum 1/2 in fiberglass insulation was used over the heating cable for lower temperature protection. Pipes must be at least 3 feet and at least 3/8” and less than 1 1/2” in. diameter. No crossing. No spiral. No overlap itself. Only straight..
  • Testing the cable before the installation. Uncoil the cable, plug in the heating cable and then put the thermostat part of the cable into an ice bucket for few minutes. When the temperature is below 37F, the thermostat will energize the cable to work. Normally you can feel the slight warm on the heating cable in few minutes. To avoid the overheat, please don’t plug in the cable for a long time for testing. When you feel the slight warm, please turn it off..
Check Stock

HEATIT HISD 12-feet Pipe Heating with Built-in Thermostat, Black

  • ... in thermostat to turn the cable 37F on 50F off. Only use 5 amps or less of electricity. Energy saving. 100% screen rate with the Aluminum foil and tinned copper braid..
  • Both CSA and ETL approved. Industrial grade heat shrinkage tube for connection. Tough XLPE as inner insulation and weather resistant PVC (high-low temperature) as out jacket..
  • Maximum 1/2 in fiberglass insulation was used over the heating cable for lower temperature protection. Pipes must be at least 3 feet and at least 3/8” and less than 1 1/2” in. diameter. No crossing. No spiral. No overlap itself. Only straight..
  • Testing the cable before the installation. Uncoil the cable, plug in the heating cable and then put the thermostat part of the cable into an ice bucket for few minutes. When the temperature is below 37F, the thermostat will energize the cable to work. Normally you can feel the slight warm on the heating cable in few minutes. To avoid the overheat, please don’t plug in the cable for a long time for testing. When you feel the slight warm, please turn it off..
Check Stock