Reviews Atx Mother Board

24/20-Pin ATX DC Power Supply Diagnostic/Breakout Board Module

• 24-pins Standard ATX Connector, support 20 / 20+4 / 24 pins wire header. With latching button switch to control ATX power supply output ON/OFF..
• Total 16 LEDs, it is convenient for you to diagnose the functions of all pins except COM/GND, therefore, if the output of any one wire of your ATX power supply is faulty, it can be seen at a glance..
• High quality screw terminal blocks. Each terminal position support current output maximum 10 Amp. Pitch 5.0mm/0.197 inch, Wire range 26AWG to 12AWG / 2.5mm square..
• Packing list: 1x Diagnostic breakout board, 4x Screws, 4x Nylon spacers..
• Special Note: The PS_ON LED lights up when the output is OFF and goes out when the output is ON, this is just the opposite of the indication status of other LEDs. Since many new ATX power supplies no longer provide output -5V, the NC/-V LED will not light up when connected to this type ATX power supply..

250 watt Pico PSU ATX Switch PSU Car Auto Mini-ITX Power Supply with Adapter Board for Computer Mainboard and car/Motorcycle

• Note：input power 11.4V-12.6V,don't too low or highg,or will be damaged！Please read the Product Description before use!.
• 250 Watt Pico PSU ATX High Mini-ITX Power Supply with adapter board.
• Pico power supply Short-circuit protection: output shut down when short-circuit.
• DC input connector: 2.5mm inner diameters, 5.5mm outer diameter.
• The atx power supply with 24 pin ATX connector, Plugs directly into the ATX connector.
• Perfect DC PSU for mini ITX Motherboards.

DC 12V 150 watt Pico PSU ATX High Mini-ITX Power Supply with Adapter Board ATX Switch PSU Car Auto for Computer Mainboard and car/Motorcycle

• 150 watt Pico PSU ATX High Mini-ITX Power Supply with adapter board.
• The mini-itx power supply Short-circuit protection: output shut down when short-circuit,.
• Pico power supply input connector: 2.5mm inner diameters, 5.5mm outer diameter.
• The atx power supply with 24 pin ATX connector, Plugs directly into the ATX connector,pico psu with adapter.
• Perfect DC PSU for mini ITX Motherboards.

Electronics-Salon 24/20-pin ATX DC Power Supply Breakout Board Module.

• Electronics-Salon 24/20-pins ATX DC Power Supply Breakout Board..
• 24-pins Standard ATX Connector, support 20 / 20+4 / 24 pins wire header..
• With latching button switch to control power ON/OFF..
• High quality 24Amp(per position) screw terminal blocks..

Rosewill ATX Slim Full Tower Gaming Computer Case with Blue LED Front Fans Case Rise Glow Black

• NOTICE: Please make sure your motherboard equipped with on-board USB 3.0 socket before purchasing.

ATX Power Supply Breakout Board and Acrylic Case Kit with ADJ Adjustable Voltage Knob, Supports 3.3V, 5V, 12V and 1.8V-10.8V (ADJ) Output Voltage, 3A Maximum Output, Reset Protection. New Version

• ATX power supply breakout board, with ADJ adjustable voltage knob, supports 3.3V, 5V, 12V and 1.8V-10.8V (ADJ) output voltage.
• The voltage output terminals of the ATX power expansion board correspond to each screw terminal..
• Compatible with 3.3V: STM32 MCU, network communication equipment, such as Wi-Fi Bluetooth and other devices, generally for microcontrollers, and some low-power modules, etc. 5V: Raspberry Pi, Banana Pi, Tinker Board, Nano Pi, USB interface, etc.
• Compatible with 9V: Arduino, motor drive, display driver module, etc. 12V: motor drive, LED light, vehicle equipment with power requirements less than 24w, etc..

anidees AI Crystal M Middle Tower Tempered Glass CEB-ATX/ATX PC Gaming Case Support 360/240 Radiator - Black AI-CL-M-LITE PC Case ONLY

• Motherboard & Radiator Support: Compatible with 12 "x 10.5" CEB, ATX Mother Board and 360/280/240 Radiator.
• Extremely spacious interior: GPU support max: 370 mm, height of the CPU cooler max: 175 mm, PSU support up to 300 mm.
• Tempered glass: 5 mm thick tempered glass on the side wall and on the front.
• Removable dust filter front, top and bottom, Front I / O: USB 2.0 x 2, USB 3.0 x 2, Audio, Mic.
• More possibility: Support 8 slots in the rear and Vertical Graphic card (up to 40mm thickness).

New Version ATX Power Supply Breakout Board and Acrylic Case Kit with ADJ Adjustable Voltage Knob, Supports 3.3V, 5V, 12V and 1.8V-10.8V (ADJ) Output Voltage, 3A Maximum Output, Reset Protection.

• 1.ATX power supply breakout board, with ADJ adjustable voltage knob, supports 3.3V, 5V, 12V and 1.8V-10.8V (ADJ) output voltage..
• 2.The voltage output terminals of the ATX power expansion board correspond to each screw terminal..
• 3. At the same time, the panel is also equipped with an acrylic case kit for easy to use..
• 4.Compatible with 3.3V: STM32 MCU, network communication equipment, such as Wi-Fi Bluetooth and other devices, generally for microcontrollers, and some low-power modules, etc. 5V: Raspberry Pi, Banana Pi, Tinker Board, Nano Pi, USB interface, etc..
• 5.Compatible with 9V: Arduino, motor drive, display driver module, etc. 12V: motor drive, LED light, vehicle equipment with power requirements less than 24w, etc..

KDMPOWER MIPC-M7350C Micro ATX 350W Power Supply

• KDMPOWER 350W MIPC-M7350C MICRO ATX Power Supply.
• Micro SFX power supplies are known mostly as a replacement power supply and can also be used for mini-ATX cases.
• 115V/230V switchable power supply (International compatible) Compatible with ATX 12V.
• 100% compatible with the following models: In-Win IP-P300BN1-0 Power Man Sparkle FSP FSP300-60GHS FSP270-50SNV FSP270-50SNVS FSP300-60GLS-MJR FSP300-60GHS-R FSP200-50SNV FSP300-60GNV FSP300-60GLS FSP300-62GL.
• Astec ATX202-3515 Bestec ATX-1523F ATX-1523D ATX-100-5 ATX-151 5184-2191 TTGI FP-250U Apex ALLIED AL-8250SFX AL-B200SFX Logisys PS350MA ISP 120SI AP-MP4ATX30.

Biostar TB360-BTC D+ (Intel 8th and 9th Gen) LGA1151 SODIMM DDR4 8 GPU Support GPU Mining Motherboard

• LGA 1151 Supports 8th and 9th Generation Intel Core Processor.
• Supports SO-DIMM DDR4-2133/2400/2666 up to 16GB Memory.
• Supports 8 x PCIe x16 slots (50mm between X16 slots).
• Motherboard Dimensions 19.1 Inch x 9.25 Inch ( W x L ).
• This motherboard has NO 24 pin ATX power supply connector it uses eight 6 pin PCIe connectors for power and has 8 PCIe connectors as outputs to power GPU's. If using a ATX power supply you will need a 24 pin jumper to start the power supply..
• Your CPU MUST have intergrated graphics. HDMI cable must be plugged into on board HDMI. This can be changed later in the BIOS if desired..

KEDIERS PC Case - ATX Tower Tempered Glass Gaming Computer Case with 9 ARGB Fans,C590

• [9 Pre-Installed 120mm ARGB Fans]-- Suitable for enhanced cooling. With the pre-installed ARGB controller you can sync it with the motherboard, each addressable ARGB fan offers 16.8 million colors for exceptional customizable lighting. You don't need to pay extra for fans. Only when the 5V-3PIN cable on the control board is connected to the motherboard can the ARGB light synchronization be realized..
• [2 Tempered glass]-- C590 gaming case is equipped 2 * 4mm thick tempered glass, which can clearly see the RGB lighting and the components in the building, Creating a good gaming atmosphere..
• [I/O Panel]-- 2 x USB3.0 Port, 1 x Type C, 1 x HD Audio, Reset Button, Power Button..
• [Cable Management]-- Back Bays: 3x 3.5'' HDD's and 3 x 2.5'' SSD's. Removable storage cable box.
• [Remarkable Expansion]-- C590 Mid Tower Gaming Computer Case supports ATX/Micro-ATX/Mini-ITX motherboards..

Thermaltake Level 20 GT Motherboard Sync ARGB E-ATX Full Tower Gaming Computer Case with 2 200mm ARGB 5V Motherboard Sync RGB Fans + 140mm Black Rear Fan Pre-Installed CA-1K9-00F1WN-02

• Light up the system - 2 Pre-installed 200mm 5V MB Sync a RGB fans (Sync with as US, Gigabyte, MSI, as rock) +1 rear black fan.
• Built-in dual-mode 5V ARGB switch board - Control light via I/O port button (27 LED modes/7 Colors) or via 5V ARGB Sync motherboard.
• 27 LED modes through I/O port button - Wave mode/ flow mode/ RGB lighting (single color)/ Radar mode (Red, yellow, green, Cyan, blue, White, Purple)/ breath mode (8 Colors)/ full lighted mode/ single color mode (7 Colors)/ light off.
• Clear view of PC gaming - four 5mm tempered glass (left & right & Front & top) with standard mounting.
• Built-in PSU cover - Removable PSU cover provides a better cable management and a tidy-looking system.
• Drive Bays - 2. 5'' Ssd x 10 or 3. 5'' X 7.
• Supports Mini ITX, Micro ATX, ATX, and E-ATX motherboard.
• I/O port - USB 3. 0 x 2, USB 2. 0 x 2, HD Audio x 1, Type-C x 1.
• Outstanding expandability - max CPU cooler height: 200mm.
• Dimension - 22. 9'' X 11. 6'' X 23. 3''. 44. 31lbs. 3 Year.

Dell Vostro 260 Inspiron 620 GDG8Y Board