Reviews Anchoring Adhesive For Concrete

Sika Anchorfix-2, Super Strength anchoring Adhesive, Two Component Anchor System for Threaded Bars in uncracked Concrete, 10.1 fl. Oz & Bosch HC2083 1\\/2 in. x 8 in. SDS-Plus Bulldog Rotary Hammer Bit

  • Product 1: Sika AnchorFix-2 is a two-Component, Solvent- and Styrene-Free, Modified-Acrylic Anchoring Adhesive..
  • Product 1: SUPPORTS: It can be used on concrete solid, masonry, steel, hard natural stone, solid rock..
  • Product 1: USES: Fast curing anchoring adhesive for rebars / reinforcing steel, threaded rods, bolts and special fastening systems..
  • Product 1: PERFORMANCE: High load capacity. Drinkable water certified. Anchoring without expansion forces..
  • Product 2: Optimized brazing and hardening process for long life.
  • Product 2: 15 percent faster (compared to S4L).
  • Product 2: Bosch-made carbide tip is tougher and more durable under heavy loads.
  • Product 2: Proprietary Bosch hardening process results in more holes per bit.
Check Stock

PC Products 72561 PC-Concrete Two-Part Epoxy Adhesive Paste for Anchoring and Crack Repair, 8.6 oz Cartridge, Gray

  • Two-part epoxy adhesive paste to fill and repair cracks in concrete, and to anchor threaded rods, bolts, and dowels into concrete, grout-filled block, and unreinforced masonry.
  • High-tack paste resists moisture for application in damp environments and can be used in vertical applications.
  • Can be used in indoor and outdoor applications with an application temperature range from 35 to 115 degrees F and a service temperature range from -20 to +115 degrees F.
  • Provides work time of 20 minutes and cure time of 4 hours (at 75 degrees F).
  • Formulated for anchoring threaded rods, bolts, rebar dowels and smooth dowels into concrete, grout filled block and unreinforced masonry..
  • PC-Concrete is excellent for filling and repairing cracks in concrete, and out-performs all caulks and hydraulic cements..
  • PC-Concrete will not come loose from any cleaned concrete surface and will hold during expansion and contraction of concrete..
  • PC-Concrete is the best solution for permanent concrete repair..
Check Stock

TentandTable 20 Foot x 30 Foot Weekender Canopy Pole Tent | Green/White | Indoor and Outdoor | 50-120 Person Capacity | for Parties, Weddings, and Events | Commercial and Residential Use

  • IMPORTANT - Pole tents are best suited for setup on GRASS or SOFT SURFACES, not recommended for hard surfaces like blacktop or concrete unless professionally installed with upgraded anchoring. Please consult your local fire marshal for tent requirements BEFORE purchase.
  • PREMIUM QUALITY - Heavy Duty 14oz. vinyl tent top, designed to withstand the wear and tear of being set up and taken down multiple times each year. Galvanized Steel tent poles.
Check Stock

TEACH Flat Head Phillips Drive Concrete Screw to Anchor Masonry, Block & Brick,270-Piece

  • Concrete Screw Flange 5/8" Head (depending on the length, it will be either full or partial threaded). The diamond tip allows for superior penetriating into hard materials. Great for anchoring items to concrete, brick, block, or other masonry materials. Ceramic coating exceeds 500/hrs salt spray resistance.
  • An externally threaded, hardened screw with a double lead, consisting of alternating raised and lowered threads with notches cut into the raised threads, and a diamond-shaped, nail-type point. Cuts its own threads and when used in concrete, block or brick. Eliminates the need for an anchor when used in light or medium-duty applications. When used in concrete, it can be removed and re-driven into the same hole. Special carbide bits are recommended for driving concrete screws into masonry..
  • Some applications include anchoring the following to masonry: electrical junction boxes, wooden beams, plywood, exterior insulation, metal flashing, thresholds. Hole should be of a depth equal to the required embedment plus 1/2”.
  • Concrete screws should be installed a minimum of ten anchor diameters between each other. They have an advantage over most other types of masonry anchors in that they can be installed close to the edge of t....
Check Stock

Makita 2 Pack - SDS-Plus 3/4” Drill Bits For SDS+ Rotary Hammers - 10' Deep Drilling Into Concrete & Masonry

  • ...ount of concrete removal for both ease of use and effectiveness in concrete/masonry drilling.
  • ✅ AVOID LOWER PRICED & lower quality bits that prematurely wear and strain or overheat the powertool, resulting in high bit consumption rate, project completion delays, ineffective drilling and making the overall drilling/anchoring much more difficult | Makita's Single-Piece Steel Bits are heat forged for strength and longevity with a sharp Carbide Tip edge design for maximum impact on masonry/concrete material, allowing for EFFECTIVE and PRECISE drilling.
  • ✅ IDEAL for General Contractors and Construction Industry that require ULTRA DUTY SDS+ bits for reliable anchoring and sturdy holes DEEP into Reinforced Concrete or Heavy-Duty Masonry | Engineered in Japan for Makita SDS-Plus Rotary Hammer Drills and also fully compatible with All SDS-Plus Rotary Hammer Drills.
Check Stock

Shorpioen 100-Pack 1/4 x 1-3/4 Concrete Screw Hex Flanged White No Drill Bit BC-1428CNHFW

  • Building Code Approved. The diamond tip allows for superior penetriating into hard materials. Great for anchoring items to concrete, brick, block, or other masonry materials. Blue ceramic coating exceeds 500/hrs salt spray resistance.
  • An externally threaded, hardened screw with a double lead, consisting of alternating raised and lowered threads with notches cut into the raised threads, and a diamond-shaped, nail-type point. Cuts its own threads and when used in concrete, block or brick. Eliminates the need for an anchor when used in light or medium-duty applications. When used in concrete, it can be removed and re-driven into the same hole. Special carbide bits are recommended for driving concrete screws into masonry..
  • Some applications include anchoring the following to masonry: electrical junction boxes, wooden beams, plywood, exterior insulation, metal flashing, thresholds. The Ruspert finish is a ceramic coating that also allows these fasteners to be used in pressure-treated lumber. Hole should be of a depth equal to the required embedment plus 1/2”.
  • The Ruspert finish is a ceramic coating that also allows these fasteners to be used in pressure-treated lumber. Check the Item Description to see if a drill is included as well..
Check Stock

BoltHold - AK-4 Asphalt Anchor & Anchoring Cement Kit - Four 1500lb Pull Rated SP10-38 Chemical Anchors 5/8 x 6 with EPX2 Anchoring Cement - For Installation of Sheds Carports Bike Racks & More

  • ASPHALT ANCHORING KIT: Stop wasting time pouring concrete! BoltHold's industrial in-ground anchors and anchoring grout allow you to install anything on asphalt in three simple steps, offering a fast, cost-effective, and reliable solution to asphalt mounting. This AK-4 Kit includes four SP10-38 (3/8"-16 x 6") Zinc-Plated Anchors with a pre-installed 1" long bolt and 1" diameter washer and two bags of EPX2 cement-based Anchoring Grout..
  • LIGHT-TO-MEDIUM LOAD: Pull rated for 1,500 lb! Designed for a light-to-medium load, BoltHold SP10-38 chemical anchors resist at least 1,500 pounds pull and 1,000 pounds of moderate shear force at ground level. Rated for 200 in-lb rotary torque, the anchor's welded spiral offers a strong bond with the grout, while the washer at the top prevents the anchor from dropping below the surface or being pulled up into the mounting plate when tightening the bolt..
  • LONG TERM STABILITY: Creates a stress-free bond that lasts! Due to asphalt's weaker nature, typical expansion-type wedge anchors used in concrete won't hold to the pressure. BoltHold anchors solve this problem by embedding deep into the compacted gravel below the asphalt layer to increase the shear resistance and ensure long-lasting stability—perfect for safely installi....
Check Stock

Sabre Tools 1/2 Inch x 18 Inch SDS Plus Rotary Hammer Drill Bit, Carbide Tipped for Brick, Stone, and Concrete (1/2\ x 16\ x 18\)

  • ...ount of concrete removal for both ease of use and effectiveness in concrete/masonry drilling.
  • ✅ AVOID LOWER PRICED & lower quality bits that prematurely wear and strain or overheat the powertool, resulting in high bit consumption rate, project completion delays, ineffective drilling and making the overall drilling/anchoring much more difficult | Makita's Single-Piece Steel Bits are heat forged for strength and longevity with a sharp Carbide Tip edge design for maximum impact on masonry/concrete material, allowing for EFFECTIVE and PRECISE drilling.
  • ✅ IDEAL for General Contractors and Construction Industry that require HEAVY DUTY SDS+ bits for reliable anchoring and sturdy holes | Engineered in Anjo Aichi, Japan for Makita SDS-Plus Rotary Hammers and also fully compatible with All SDS-Plus Rotary Hammers.
Check Stock

Kelaro EZ Dishwasher Mounting Bracket Kit for Granite and Quartz Countertops W10426979

  • Ideal for granite, quartz, marble, glass, concrete and other solid surface countertops where screws can't be directly secured to the counter material..
  • Eliminates anchoring problems and accommodates most common 24" dishwashers. Simply screw in the dishwasher clips to the EZ bracket. Package contains (1) Dishwasher Bracket and (6) mounting screws. Bracket is 26.5" long, 1.75" wide and 0.25" tall. (Not compatible with thin 18" dishwashers)..
  • Can be installed before counter top installation by screwing bracket into the top of cabinets. Or after, by bending the bracket end tabs down to install to the sides of cabinets. More reliable than adhesive grabbers that will fail with dish washer vibrations..
  • Perfect for homeowner or contractor installation. New builds or remodels. Dishwasher does not have to be present for installation..
  • MADE IN USA from 22 gauge galvanized steel. Compatible part numbers: W10426979, 231179, AH3632890, EA3632890, PS3632890. Fits these common brands: Whirlpool, KitchenAid, Maytag, Amanda, Jenn-Air, Estate, Roper, Admiral, Magic Chef and others..
Check Stock

American Ground Screw U-Model Premium No Dig Ground Anchor - Screw in Post Stake - 27\

  • Concrete Free! No need to bother with digging, mixing, or waiting for concrete to set. The U-Model is 100% loadable immediately after installation.
  • Securely Holds 4x4 Posts, Five Lag Bolts Included.
  • Made with Hot-Dipped Galvanized Steel to Guarantee Structural Integrity for Decades to Come!.
Check Stock

100 Pcs 1/4 x 3 Heavy Duty Nail Drive Anchors Rustproof Drive Pins Zinc Plated Drive Anchors for Metal Steel Aluminum Angles Wood Concrete Hammer Fasteners Kit

  • A Box of 100: there are 100 pcs of 1/4" x 3" drive nail anchors in the package, plenty enough to use and replace to easily meet your daily and party needs.
  • Size Information: with a size of approximately 1/4" in diameter and 3" in length, this heavy duty nail drive anchor requires drilling a 1/4" diameter hole in concrete prior to installation.
  • Please confirm the size before placing an order.
  • Strong and Reliable: featuring zinc plated steel material, heavy duty drive nail in anchors are strong and reliable, not easy to break, deform, bend or rust, easy to serve you for a long time.
  • Practicality: these zinc plated nail drive anchors can fasten sheet metal, steel, aluminum angles, wood, etc., to concrete, ideal for structural anchoring, shelf anchoring, mechanical and handrail installations.
  • Easy to Install: 1/4 x 3" drive anchors are simple to apply, hit them into the reserved hole with a hammer, and they can be easily installed without additional tools, saving time and effort.
  • Note: anchors cannot be taken out after use, please confirm the insertion point before use.
Check Stock

DRICORE PRO Concrete Repair Structural Epoxy Injection Resin Kit (10') | Best All in One Set with Injectable Filler for Repairing Cracked Foundations, Walls, Basements, Cement Structures

  • NEW, EASY, SAFE: DRICORE PRO Concrete Repair Structural Epoxy Injection Resin Kit (10') contains everything you need to inject, fill, and repair cracks up to 10’ in length — One Tube of DRICORE PRO Concrete Repair Structural Epoxy Injection Resin, One Tube of DRICORE PRO Concrete Repair High Strength Anchoring Epoxy Paste, Two Static Epoxy Nozzles, Ten Ports, Gloves, and Instructions.
  • MULTI-PURPOSE: Our repair pack is made to fill concrete that is cracked, broken, or split. For best results, be sure to follow the instructions closely. Consult a professional if you are not experienced with fixing or repairing concrete..
  • MADE FOR THE TASK: DRICORE PRO Concrete Repair Structural Epoxy Injection Resin Kit (10') is a high strength and water resistant concrete repair set for concrete repair jobs. Versatile enough to use both at home and at work, our industrial strength kit is great for contractors and experienced DIY repairmen doing home projects, basement, garage renovations, and more.
  • COST EFFECTIVE, SIMPLE TO USE: Our repair kit is a relatively cheap but effective way to fix your clients’ concrete structure, apartment, condo, or house. Save both time and money by using our specially engineered and designed repair package for your next project or conc....
Check Stock

Pool Boy II Automatic Solar Reel with Remote Control

  • Select cover based on your pool size. Actual cover measures approximately 2-ft wider and 2-ft longer.
  • Comes complete with all hardware to install on concrete decking.Fabric Type:Polyethylene.
  • Includes: brass anchors, stainless-steel springs, buckles, installation tools, and storage bag.
  • Drill and tamp style brass anchoring system permanently secures anchors in concrete.
  • Multi-seamed stitching ensures safety and prevents wear and tear.
  • Stainless steel hardware resists damage from the elements.
  • High scrim mesh panel design lets water though but protects pool against dirt and debris.
  • Reinforced wear strips on underside of cover to guard against cover abrasion and fraying.
Check Stock