Reviews 2 Hp Motors

Carburetor Carb for Hangkai 3.5HP 3.6HP 2-Stroke Boat Outboard Engine Motor

  • Fitment: for 3.5HP 3.6HP 2 strokes Boat Outboard engines motors.
  • Good working condition and easy to install..
  • Carburetor for Hangkai 3.5HP 3.6HP 2-Stroke.
  • Pre-adjusted carb before shipping, no extra adjustment needed,Replaces existing stock carburetor, just replace and ride again..
Check Stock

New 5HP Electric Motor for air Compressor 56 Frame 3440 RPM 5/8' Shaft 20.3 AMP 230 Volt

  • Brand NEW WEG Compressor Duty Electric Motor 5HP 56 FRAME 20.3 AMP 230 VOLT.
  • DESIGNED TO REPLACE 56 FRAME MOTORS ONLY, INCLUDES MANUFACTURERS WARRANTY.
  • 5HP 56 FRAME 3440 RPM 5/8" SHAFT DIAMETER.
  • 230 VOLT MOTOR ( NOT SUITED FOR 208 VOLT APPLICATIONS).
  • WILL REPLACE 56 FRAME 5/8" MOTORS AND 5HP SPL MOTORS UNDER 15-21FL AMPS @ 230VOLTS.
Check Stock

Kailh White Owl V2 Switch RGB SMD Clicky 70g Switches for Mechanical Keyboard mx stem 5pin White Grey (White Owl Switch x70)

  • MOMENTARY SWITCH: (spring action) only engages while the user is pushing the handle. This switch will spring back to off position when handle is released..
  • WIRING: Please refer to your motors wiring instructions on how to wire switch.
  • Max 1.5 HP at 120Vac Motors or Max 2 HP at 240Vac Motors.
  • Highly visible red handle with enclosure that is IP65 rated..
Check Stock

PANTHER MARINE O/B Motor Bracket SS 15HP MAX

  • Works with 4-stroke motors up to 15 HP or 2-stroke motors up to 20 HP with a maximum weight of 132 lbs..
  • Twist-knob safety locks provide increased torque rating while helping secure the bracket in place.
  • Built extra tough and extra wide for heavier 4-stroke engines.
  • Heavy-duty stainless steel torsion springs for easy lifting.
  • 4-position lock bar and 11" of travel allows for a better range of trim adjustments.
Check Stock

Stainless Steel 20hp Outboard Motor Bracket Kicker for Boat

  • Material: Stainless steel, Base is made of plastic..
  • Mounting Size 8” × 8-5/8”, Broad Size: 8-1/4” × 10-3/8”..
  • Perfect for sailboats, powerboats, locks and holds motor up or down in two vertical running positions..
  • Fits most style of 2-stroke outboard motors.
Check Stock

NEW SCHULZ SINGLE STAGE CAST IRON AIR COMPRESSOR PUMP 2, 3 OR 5 HP + FREE FILTER

  • MSL-18MAX SCHULZ INDUSTRIAL GRADE SINGLE STAGE AIR COMPRESSOR PUMP FOR 2HP, 3HP, 4HP AND 5HP APPLICATIONS.
  • 12 MONTH WARRANTY, PUMP SPECIFICALLY DESIGNED FOR 2HP - 5HP 56FRAME ELECTRIC MOTORS RATED BETWEEN 15-20 AMPS, FREE IN-TAKE FILTER INCLUDED.
  • 18 CFM DISPLACEMENT MAX, 42 LB CAST IRON 2 CYLINDER PUMP, MAXIMUM PRESSURE 125 PSI.
  • MANUFACTURERS SUGGESTED RPM 1190, PUMP FLYWHEEL 11.5" OUTSIDE DIAMETER SINGLE GROOVE FOR ONE BELT, 1/2" TOP WIDTH A/4L SECTION BELT. BELT NOT INCLUDED.
  • PLEASE READ DESCRIPTION FOR FULL DETAILS, DIMENSIONAL DATA CAN BE VIEWED ON ATTACHED PICS.
Check Stock

Outboard Rectifier 3 Wires Fits for 1980-2001 Johnson Evinrude 15 60 65 75 85 88 9.9 90 100 110 112 115 140 150 175 200 235 HP, Voltage Marine Regulator 18-5708 583408 582399 580795 581603

  • Voltage Regulator Rectifier Fits for Johnson Evinrude Outboard Motors, Repl. OEM# 580765 580795 582399 583408 581603 582307 580841 581305 583408 Sierra 18-5708. Compatible Models 50HP 1971-1975, 55HP 1976-1977, 60HP 1970-1971, 1986-1991, 65HP 1972-1973, 1989 , 65HP Comm 1984-1991, 70HP 1973-1991, 75HP 1975-1976, 1978-1988..
  • Voltage Regulator Rectifier Fits for :85HP 1970-1983, 88HP 1987-1996, 90HP 1984-1990, 1994, 1996-1997 , 100HP 1967-1968, 1971-1972, 1990, 1994, 100HP Comm 1987, 1990, 110HP 1986-1989, 112HP 1994-1996, 115HP 1969-1970, 1973-1985, 1990, 1994, 1997, 125HP 1971-1972, 135HP 1973-1984, 150HP 1978, 175HP/185HP 1977-1978, 200HP 1976-1978, 235HP 1978, 2.5/2.6 L SEA DRIVE 1982, 1.6 L SEA DRIVE1983 , 2.6 L SEA DRIVE 1983..
  • Brand new Voltage Regulator Rectifier Made of use high quality aluminum, highest grade lamination materials,higher grade of electronic components. Achieves greater stability and reliability than ordinary brands. It will match even exceed OEM parts in compatibility and performance.
  • This rectifier has overheat protection, helps to dissipate excess voltage, prevents over-charging battery, improves heat sink and charging capabilities. Replace a new regulator rectifier can raised your lights brightness, improve the phenomenon of l....
Check Stock

Annurssy Brackets & Hinge Assembly for Boat Engine Outboard Electric Trolling Motor

  • Approved for up to 40hp motors (for motors without factory trim and tilt or standard BIA bolting pattern).
  • Works with 0-20hp motors with electric trim and tilt.
  • The Mini Electric On The Fly Jack Plate is easy to install.
  • Our jack plates can be raised and lowered by a up/down push button while on the water within seconds from top to bottom..
  • 3 year warranty on the jack plate housing - 1 year warranty on the electric actuator.
Check Stock

BaQiRo Stainless Steel 20hp Outboard Motor Bracket Kicker for Marine Boat

  • With the sturdy design and smooth, spring‑assisted action, it is quick and easy to lift auxiliary or kicker motor..
  • Mounting Size 8” × 8-5/8”, Broad Size: 8-1/4” × 10-3/8”..
  • Full adjustable, 4‑position mounting plate accommodates a wide variety of motor and transom configurations..
  • Fits most style of 2-stroke outboard motors.
Check Stock

BYS VRO Oil Injection Conversion Fuel Pump Kit for Johnson/Evinrude 5007420 5007422

  • ▶ This VRO system conversion non-oiling fuel pump for 90hp-250hp Johnson & Evinrude Outboard motors. Fits V6 Crossflow and Looper engines but DOES NOT fit 60 degrees applications..
  • ▶ Replace Part Number：for Johnson/Evinrude 5007420,5007422.
  • OMC part # 4-7359； EMP part # 1399-07359. Interchange Part Number: for Volvo 5007420.
  • ▶ Compatibility: 5007420 VRO system conversion non-oiling fuel pump for 90hp-250hp Johnson & Evinrude Outboard motors..
  • ▶ 5007420 VRO Oil Injection Conversion Fuel Pump is specially designed to exact OEM standards manufactured and tested,to help deliver optimum performance in Johnson/Evinrude engines,provides a good engine performance,which gives your machine the new power and torque it really deserves..
  • ▶ Package Includes: 1x VRO Oil Injection Conversion Fuel Pump Kit..
Check Stock

MOOSUN Centrifugal Clutch 3/4' Bore #35 Chain 12 Tooth for Go Karts Mini Bike Replace Parts (12T Centrifugal Clutch with #35 Chain)

  • Centrifugal Clutch 3/4" Bore 12 Tooth for 35 Chain Common clutch for 2-7 HP engines 2300±300 PRM.
  • Fits Honda GX160 GX200 GX140 GX120 GC160 GC190 Harbor Freight Greyhound 196cc Harbor Freight Predator 212cc.
  • Fit Briggs and Stratton Tecumseh engines and 2-6.5 HP with 3/4" shaft Tecumseh Engines.
  • Also fits any other engines with 3/4 crank shaft and 3/16" key way, most 5.5 HP clones, 6.5 HP clones and 4-7HP motors in all brands.
  • Go Kart Clutch kit includes two set screws and chain.
Check Stock

Boat Outboard Motor Bracket, Marinebaby Aluminum outboard Engine Support

  • Suitable for 2-stroke Motors 7-1/2 HP to 20 HP.
  • Stainless Steel Springs Counter-balance Motor Weight.
  • Broad Size: 8-1/4" * 10-3/8" (210mm*264mm).
  • Mounting Size 5-1/4” * 9” (133.35mm*228.6mm).
Check Stock

M-Y Wedge Motor Support FITS 3-Ram Trim/Tilt Systems

  • Suitable for 2-stroke Motors 7-1/2 HP to 20 HP.
  • Broad Size: 8-1/4" * 10-3/8" (210mm*264mm).
  • Designed for use with power or sail boats.
  • Mounting Size 5-1/4” * 9” (133.35mm*228.6mm).
Check Stock